bluebuilt Era 100 Wall Mount for Sonos User Guide
- June 1, 2024
- bluebuilt
Table of Contents
bluebuilt Era 100 Wall Mount for Sonos
In the box
From your own toolbox
CHECKLIST
Does the tick.
Suitable surfaces:
-
Wood
-
Drywall
-
Concrete
-
Brick
-
Do you have a question?
Coolblue.nl/en/customer-service Coolblue isn’t liable for any injury, damage, or arguments with your partner caused by a wrong installation. Not sure if you can do this yourself -
Ask a professional installer.
INSTALLATION INSTRUCTIONS
- Place the mounting plate 3 on the speaker stand 2 and tighten the screws.
- Place the speaker on the mounting plate 3 and tighten the screws at the bottom. Feed the cable through the hole in the mount.
- With the spirit level, measure the height of the wall mount 1 . Make sure that the mount is straight. Mark the drill holes with the pencil.
- Wooden wall : drill a 3.5mm wide and 50mm deep hole and screw the wall mount 1 with the screws to the wall.
- Stonewall : drill a 8mm wide and 50mm deep hole. Place the plugs 5 around the screws 4 and screw the wall mount 1 to the wall.
- Attach the speaker stand 2 to the wall mount 1 and optionally store away the cables with the zip tie 7.
- Tilt the speaker upwards or downwards or move it to the left and right. This way, you can adjust the sound to your liking.
- BlueBuilt is a registered trademark of Coolbue B.V., Weena 664, 3012 CN Rotterdam, The Netherlands.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>