Eastbrook GL43DB Freestanding Bath with metal Feet Instruction Manual
- September 25, 2024
- Eastbrook
Table of Contents
GL43DB Freestanding Bath with metal Feet
“`html
Product Specifications:
-
Installation: Requires two people
-
Weight Limit: Not designed for sitting or standing on the
rim -
Parts Included: Bath feet and waste supplied separately
-
Maintenance: Clean with a soft damp cloth, avoid harsh
chemicals -
Technical Helpline: 01452 317890
-
Email: technical@eastbrookco.com
-
Address: Eastbrook Road, Gloucester GL4 3DB
Product Usage Instructions:
Receive Your Bath:
Ensure you have the following tools: Adjustable Wrench.
Installation:
-
Place the bath on a soft surface to prevent scratches.
-
Attach bars, washers, and nuts without tightening to allow for
adjustments. -
Position feet onto bars and secure with provided nuts and
bolts. -
Adjust feet position to align with the bath.
-
Tighten all nuts to secure feet and bars in place.
Maintenance & Cleaning:
Clean marks with a soft damp cloth or toothpaste for stubborn
marks. Avoid harsh chemicals or abrasives. Test colored oils/creams
on a small area before use.
Warning:
If the bath has a tap deck, drill tap holes as needed. Silicone
tap holes after drilling and check for water leakage at the
faucet.
FAQ:
Q: What should I do if there is movement in the feet after
assembly?
A: Ensure the feet are properly assembled, and check the
placement of washers and fasteners.
“`
Maintenance & Instructions
Important information
Two people are required for installation. Please read these instructions
thoroughly and retain for future reference Always check for pipes and cables
before drilling Freestanding bath is not designed to take weight on the rim,
Do not sit or stand on the bath rim. Bath feet and waste are supplied
separately.
Parts List
Image for installation purpose only
Please retain this manual after installation for future reference and
maintenance Product must be installed in compliance with relevant Water Bylaws
Receive Your Bath
Unpack and check for damage. After receiving your bath, please unpack and
remove all packaging, checking for damage, damage reported after painting will
not be covered. Repack the bath if it is not being immediately installed.
Metal bars required for feet installation are attached to the underside of the
bath. Protect your bath. Before commencing installation, ensure the bath is
completely protected, leave covering in place until the bathroom is complete.
Scratches and damage incurred during installation are not covered by the
warranty.
TOOLS REQUIRED
Adjustable Wrench Installation Step 1 Ensure the bath is on a soft surface to
protect against scratches. Place the bars onto the bath, along with the
washers and nuts as shown below, do not tighten at this stage to allow for
adjustment, taking care not to damage the bath surface.
Step 2
Position the feet onto the bars and secure using the nuts and bolts provided.
Adjust the position of the feet to align with the bath. Tighten all of the
nuts so that the feet are secured to the bar and the bars are secured to the
bath.
Troubleshooting
Movement in the feet after assembly Please check the feet are assembled
properly, make sure fastener washers and washers are placed correctly.
Maintenance & Cleaning
Marks on the surface of the bath, should be cleaned using a soft damp cloth,
for more stubborn marks, toothpaste can be applied and then rinsed thoroughly.
No harsh cleaning chemicals or abrasive materials can be used on any surface.
If using coloured oils/creams, carry out a test on small area prior to use to
ensure that these will not cause staining. Never pour coloured oils/creams
directly into an empty bath, always apply them into the bath water.
Warning
Pay attention to below points if the bath is designed with tap deck. The tap
holes are not pre-drilled on the deck, drill holes according to your need.
Check and silicone the tap holes to make sure they are solid after drilling.
Check and make sure that there is no water leakage at the faucet.
Technical Helpline: 01452 317890 Email: technical@eastbrookco.com Eastbrook Road, Gloucester GL4 3DB
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>