Eastbrook 98.2021 Bathtub Tap Installation Guide
- July 31, 2024
- Eastbrook
Table of Contents
Installation and operation instruction
98.2021 Bathtub Tap
Consult a qualified plumber if you have any problems installing this product
Guarantee & Aftercare
When installing or using tools, extra care must be taken to avoid damaging the finish or fitting. To maintain the appearance, please ensure it is cleaned regularly using a clean soft damp cloth only. Abrasive cleaners or detergents must not be used as they may cause surface deterioration. The company provides a guarantee against faulty material or manufacture excluding serviceable parts, providing they have been installed, cared for and used in accordance with our instructions.
What you receive is whole unit, please.
- Remove Plastic nut 5 and Rubber washer 4 accessories in turn.
- Put the two G3/4 inlet connector pipe of tap body into the mounting holes on the bathtub top.
- Put two Rubber washer4 on the G3/4 connector pipe 3, and then fix the tap body with plastic nut 5 .
- Connect the two G3/4 inlet connector pipes to cold and hot water supply separately .
- Connect cold and hot water, and check all water feed connections to ensure there are no leaks.
Use and maintenance Figure II
-
After using for a period of time, if the handle is found tobe loose or shaking, the maintenance can be carried outaccording to the following methods:
1. 1. Screw off the handle spindle by hand, and then tighten the M 6 screw with S 3 Allen Key.
1.2. Turn the handle to check whether the handle stillshakes.
If not, install the handle spindle. -
Turn the left handle clockwise to turn on the hot water, and turn the right handle counter clockwise to turn on the cold water.