Xiamen iD888 Mini Printer User Guide
- September 24, 2024
- Xiamen
Table of Contents
Xiamen iD888 Mini Printer
Packing List
Note: The packing items are based on the order.
Appearance and Components
- Feed Button
- Cover Opening Button
- Power Receptacle
- Power Switch
- USB Intertace
- Ethernet Interface
- Locking Tab
- Platen
- Movable Sensor
- Movable Roll Holders
Do not touch the sharp edges.
Note: The interface shown in the figure above is for reference only.
Power Supply
- Make sure the printer is turned off.
- Connect the power adapter to the printer.
- Connect the power adapter to the power cord.
- Plug the other side of the power cord into the socket outlet.
Paper Loading
- Press the cover opening button and lift the cover.
- Pull the roll holders open and place the roll between them.
- Confirm that the paper roll is tightly attached to the roll holders, and press down the locking tab.
- Press down the cover until it snaps closed.
Note: Please refer to windows driver installation in the user manual.
FCC COMPLIANCE STATEMENT
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received,including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications to this unit not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment.
FCC Radiation Exposure Statement
This equipment complied with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
Manufacturer: Xiamen Hanin Co., Ltd.
Address: No.96, Rongyuan Road, Tong’an District, Xiamen, Fujian, China 361100
E-mail: support@idprt.com
Web: www.idprt.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>