DATALOGIC JTSSDCOII Joya Touch Single Slot Dock Charge Instruction Manual

DATALOGIC JTSSDCOII Joya Touch Single Slot Dock Charge

Specifications

• Manufacturer: Datalogic S.r.l.
• Model: Joya Touch Single Slot Dock Locking
• Power Supply: UL Listed/CSA Certified Power Unit LPS/SELV rating 5Vdc 1.5A
• Wireless: Radio modules adapt to system frequencies

Product Usage Instructions

Safety Precautions
Follow these general safety rules to ensure safe usage of the Joya Touch Single Slot Dock Locking:

• Avoid inserting foreign objects into the dock slot.
• Expect the device to get warm during charging, which is normal.

Power Supply

The device requires a specific power supply for operation

• Use only a UL Listed/CSA Certified Power Unit with LPS/SELV rating 5Vdc 1.5A.
• Do not make any changes or modifications to the equipment without approval as it could void the warranty.

Wireless and Radio Frequencies
For wireless operation, ensure compliance with the following

• Set system frequencies according to the country’s spectrum requirements.
• The radio modules automatically adjust to the system frequencies.

FAQ
Q: What should I do if the device is not charging properly?
A: Check that the power supply meets the specified requirements and ensure no foreign objects are obstructing the dock slot.

SAFETY & REGULATORY ADDENDUM

Single Slot Dock Charge Only
©2017-2024 Datalogic S.p.A. and/or its affiliates

All rights reserved • Without limiting the rights under copyright, no part of this documentation may be reproduced, stored in or introduced into a retrieval system, or transmitted in any form or by any means, or for any purpose, without the express written permission of Datalogic S.p.A. and/or its affiliates • Datalogic and the Datalogic logo are registered trademarks of Datalogic S.p.A. in many countries, including the U.S. and the E.U.

This document is an addendum to the Quick Start Guide (QSG) for this product. See the QSG for additional product information.

www.datalogic.com

NOTE: Read carefully the Joya Touch Single Slot Dock Locking Quick Start Guide before performing any type of connection to the Joya Touch Single Slot Dock Locking. The user is responsible for any damage caused by incorrect use of the equipment or by inobservance of the indication supplied in the user manual.

GENERAL SAFETY RULES

CAUTION

• Before using the Joya Touch Single Slot Dock Locking, read this Addendum carefully.
• Before using the Joya Touch 22 devices and the battery packs, read also the Joya Touch 22 Safety & Regulatory Addendum.
• Use only the components and accessories supplied by the manufacturer for the specific Joya Touch 22 being used.
• Do not attempt to disassemble the Joya Touch Single Slot Dock Locking, as it does not contain parts that can be repaired by the user. Any tampering will invalidate the warranty.
• Do not submerge the Joya Touch Single Slot Dock Locking in liquid products.
• For further information or support, refer to the Datalogic web site: www.datalogic.com
• CAUTION: Do not put any foreign object such as, but not limited to, coins, paper clips, stickers inside the slot of the dock (see the examples below).

NOTE: The Joya Touch 22 gets warm during charging; this is normal and does not mean a malfunction.

POWER SUPPLY
The device is intended to be supplied by a UL Listed/CSA Certified Power Unit LPS/SELV rating 5Vdc 1.5A power source which supplies power via the power connector of the cable.
Any changes or modifications to equipment, not expressly approved by Datalogic could void the user’s authority to operate the equipment.

WIRELESS AND RADIO FREQUENCIES
WARNINGS

• WARNING: Do not attempt to charge any other device different from Joya Touch 22 devices.
• Make sure there’s nothing between charger and the device.
• Do not insert nor attach anything, such as stickers, inside the dock slots.
• Use only the supplied or an approved replacement antenna. Unauthorized antennas, modifications or attachments could damage the product and may violate laws and regulations.
• Most modern electronic equipment is shielded from RF signals. However, certain electronic equipment may not be shielded against the RF signals generated by Joya Touch 22.
• Datalogic recommends persons with pacemakers or other medical devices to follow the same recommendations provided by Health Industry Manufacturers Associations for mobile phones. Persons with pacemakers should ALWAYS keep this device more than twenty  five (25) cm from their pacemaker and/or any other medical device.
• Do not install the dock in any area with a potentially explosive atmosphere. Observe restrictions and follow closely any laws, regulations, warnings and best practices on the use of radio equipment near fuel storage areas or fuel distribution areas, chemical plants or  where any operation involves use of explosive materials.
• Do not store or carry flammable liquids, explosive gases or materials with the device or its parts or accessories. Areas with a potentially explosive atmosphere are often, but not always, clearly marked or shown. Sparks in such areas could cause an explosion or fire,  resulting in injury or even death.
• This device must be installed and operated with minimum distance of 10 cm between the radiator and user’s body.

MARKING AND EUROPEAN ECONOMIC

AREA (EEA)
In radio systems configured with mobile computers and access points, the frequencies to be used must be allowed by the spectrum authorities of the specific country in which the installation takes place. Be absolutely sure that the system frequencies are correctly set to be compliant with the spectrum requirements of the country. The Radio modules used in this product automatically adapt to the frequencies set by the system and do not require any parameter settings.

European Declaration of Conformity
Hereby, Datalogic S.r.l. declares that this radio equipment is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at: www.datalogic.com . Select the Support & Service > Downloads > Product Certifications link where you can search for your specific product certification.

UKCA DECLARATION OF CONFORMITY

Hereby, Datalogic S.r.l. declares that this radio equipment is in compliance with the Radio Equip-ment Regulations 2017 (S.I. 2017/1206) and that the full text of the UKCA Declaration of Confor-mity is available at the following internet address: http://www.datalogic.com Select the Support & Service > Downloads > Product Certifications link where you can search for your specific product certification.

UK importer information:
Datalogic S.r.l. UK
Hertfordshire – United Kingdom

INFORMATION FOR THE USER
Contact the competent authority responsible for the management of radio frequency devices of your country to verify any possible restrictions or licenses required.

FCC/IC LABELING

FCC COMPLIANCE
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause unde-sired operation.

NOTICE
Changes or modifications made to this equipment not expressly approved by Datalogic S.r.l. may void the FCC authorization to operate this equipment.

NOTE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful inter-ference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:\

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.
  Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

• This device complies with Part 15C of the FCC Rules. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

• If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the inter-ference by one or more of the following measures:

• Increase the separation between the equipment and any other radio device.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

RF Exposure compliance may be ensured only for a minimum separation distance that is greater than 20 cm.

ISED COMPLIANCE

NOTICE
This device complies with Industry Canada licence-exempt RSS standard(s).

Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

CAUTION
Exposure to Radio Frequency Radiation

1. To comply with the Canadian RF exposure compliance requirements, this device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.
2. To comply with RSS 102 RF exposure compliance requirements, a separation distance of at least 10 cm must be maintained between the antenna of this device and all persons.

RADIOFREQUENCY RADIATION EXPOSURE INFORMATION

This device was tested for E and H field to demonstrate compliance with RF exposure limits, according to international Standards covering human exposure to electromagnetic fields from radio devices.
More information about the relevant Standards for RF exposure measurement methods and procedures may be found in the CE DoC included in the product user manual available at http://wwwdatalogic.com website and at the FCC public listing

under the FCC IDs specified in the FCC/IC labeling section.
This device is compliant with RF exposure limits for general population/uncontrolled exposure specified in Council Recommendation 1999/519/EC Annex II.

RADIO TECHNOLOGIES AND FREQUENCY BANDS
The dock incorporates the following radio technologies and supports the corresponding frequencies, as specified below:

CLEANING THE DOCK

• Periodically clean the Joya Touch Single Slot Dock Locking using a soft cloth slightly dampened with only water or Isopropyl Alcohol (70%).
• Do not use any other cleaning agents (e.g. different alcohol, abrasive or corrosive products, sol-vents) or abrasive pads to clean the dock.
• Do not spray or pour liquids directly onto the dock.
• The dock is not water resistant. Keep it dry.

Datalogic S.r.l.
Via San Vitalino 13
40012 Calderara di Reno (BO)

Italy
Tel. +39 051 3147011
Fax +39 051 3147205

©2017-2024 Datalogic S.p.A. and/or its affiliates
All rights reserved. Without limiting the rights under copyright, no part of this documentation may be reproduced, stored in or introduced into a retrieval system, or transmitted in any form or by any means, or for any purpose, without the express written permission of Datalogic S.p.A. and/or its affiliates.
Owners of Datalogic products are hereby granted a non-exclusive, revocable license to reproduce and transmit this documentation for the purchaser’s own internal business purposes. Purchaser shall not remove or alter any proprietary notices, including copyright notices, contained in this documentation and shall ensure that all notices appear on any reproductions of the documentation.
Electronic versions of this document may be downloaded from the Datalogic website ( www.datalogic.com ). If you visit our website and would like to make comments or suggestions about this or other Datalogic publications, please let us know via the “Contact” page.

Disclaimer
Datalogic has taken reasonable measures to provide information in this manual that is complete and accurate, however, Datalogic shall not be liable for technical or editorial errors or omissions contained herein, nor for incidental or consequential damages resulting from the use of this material. Datalogic reserves the right to change any specification at any time without prior notice.

Trademarks
Datalogic and the Datalogic logo are registered trademarks of Datalogic S.p.A. in many countries, including the U.S.A. and the E.U.
The Joya logo is a trademark of Datalogic S.p.A. and/or its affiliates, registered in the U.S. and the E.U. All other trademarks and brands are property of their respective owners.

WEEE STATEMENT

Waste Electrical and Electronic Equipment (WEEE) Statement

For information about the disposal of Waste Electrical and Electronic Equipment (WEEE), please refer to the website at www.datalogic.com

• Parentheses indicate an open interval, it does not include its endpoints

References

• Datalogic | Automatic Data Capture and Industrial Automation - Datalogic

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>