DATALOGIC DL36VSD Handheld Vehicle Dock User Guide
- June 3, 2024
- DATALOGIC
Table of Contents
Vehicle Dock
MODEL: DL36VSD
Quick Start Guide
**Out of the Box
**
The package contains:
- Dock
- Quick Start Guide
- Safety & Regulatory Addendum
Remove all the components from their packaging; check their integrity and
compare them with all the packing documents.
CAUTION
Keep the original packaging for use when sending products to the technical
assistance center. Damage caused by improper packaging is not covered under
the warranty.
General View
Vehicle Dock
Mount the Ram Mount Adjustable Arm
The Ram Mount Adjustable Arm is available as optional accessory (P/N
94ACC0075) and allows wide range of rotation for the dock. It can be mounted
on any flat surface while the ball joints enable position flexibility.
- Align the adjustable arm with the two screw holes on the rear of the dock as shown in the figure below:
- Secure the adjustable arm to the rear of the dock using two screws M5X10 and two nuts M5:
CAUTION
Install only on properly grounded mobile platforms. If this dock is used on an
electric vehicle, ensure that no part of the dock and PDA can come into
contact with the vehicle chassis. Electrical discharges can develop on these
vehicles, which can damage the dock and/or PDA.
CAUTION
Do not install the dock on or near an airbag cover plate or a blower.
Do not install it in a location that may affect vehicle safety, visibility and
driveability.
Power the Dock
- Plug in the cigarette lighter adapter¹ into your vehicle’s cigarette lighter.
- Insert the cigarette lighter adapter output plug in the dock power jack (see figure below). When the dock is powered, the Power ON LED lights up solid green.
CAUTION
Make sure your vehicle’s power source is between 10 to 30 VDC, and is capable
of supporting a 4000mA current drain. If you have any concerns regarding this,
refer to your vehicle owner’s manual.
CAUTION
The cigarette lighter adapter must not be used if the battery car is fully
depleted.
NOTE
To reduce quiescent current and extend battery life, disconnect the dock when
the car is not powered.
¹Available as accessory:
- 94A050045 POWER ADAPTER 12/24VDC CLA, MEMOR 10 (U.S. Models)
- 94A050048 POWER ADAPTER,12/24VDC CLA, MEMOR 10 (E.U. Models)
Charge the Memor 10
To insert the Memor 10 into the dock, the rubber boot is needed.
The rubber boot provides additional protection to the device and is available
as optional accessory (P/N 94ACC0193 for; standard models; P/N 94ACC0204 for
healthcare models).
Insert the Memor 10 with the rubber boot into the dock with the screen facing front and the head facing up.
CAUTION
Make sure there is nothing between the dock and the device.
Do not put any foreign object such as, but not limited to, coins, paper clips,
stickers inside the slot of any of the docks.
Do not apply any sticker to the Memor 10 (see the examples below).
WARNING
Do not attempt to charge any other device different from the Memor 10 devices.
CAUTION
Do not use the Memor 10 while driving. The user is responsible for driving
safely.
LED Indicators
| LED Behavior | Operation Status |
|---|
Power ON
Solid green| Dock is powered
Foreign Object Detection (FOD)
Blinks red slow at 0.625Hz| Foreign object detected, output power is reduced.
Blinks red fast at 2.5Hz| Foreign object detected, output power is further
reduced.
Solid red| Foreign object detected, output power is disabled.
CAUTION
In case of FOD led blinking, remove the foreign object.
Technical Specifications
Electrical Features
Power Supply (with CLA)| From 10 to 30 VDC
Indicators Consumption| Power on LED (green)
FOD LED (red)
Environmental Features
Working Temperature| 0°C to 40°C
Storage Temperature| -30°C to 70°C
Humidity| 5-95% non-condensing
Vibration Resistance| EN60068-2-64
Shock Resistance| EN60068-2-27
Mechanical Features
Dimensions| 202 x 89 x 61 mm / 7.9 x 3.5 x 2.4 in
Weight| 269 g / 9.48 oz
335 g / 11.82 oz (with cigarette lighter power adapter)
Datalogic S.r.l.
Via San Vitalino 13
40012 Calderara di Reno (BO)
Italy
Tel. +39 051 3147011
Fax +39 051 3147205
©2022 Datalogic S.p.A. and/or its affiliates
♦ All rights reserved.
♦ Without limiting the rights under copyright, no part of this documentation
may be reproduced, stored in or introduced into a retrieval system, or
transmitted in any form or by any means, or for any purpose, without the
express written permission of Datalogic S.p.A. and/ or its affiliates. Owners
of Datalogic products are hereby granted a nonexclusive, revocable license to
reproduce and transmit this documentation for the purchaser’s own internal
business purposes. Purchaser shall not remove or alter any proprietary
notices, including copyright notices, contained in this documentation and
shall ensure that all notices appear on any reproductions of the
documentation. Should future revisions of this manual be published, you can
acquire printed versions by contacting your Datalogic representative.
Electronic versions may either be downloadable from the Datalogic website (
www.datalogic.com ) or provided on appropriate
media. If you visit our website and would like to make comments or suggestions
about this or other Datalogic publications, please let us know via the
“Contact Datalogic” page.
Disclaimer
Datalogic has taken reasonable measures to provide information in this manual
that is complete and accurate, however, Datalogic reserves the right to change
any specification at any time without prior notice. Datalogic and the
Datalogic logo are registered trademarks of Datalogic S.p.A. in many
countries, including the U.S.A. and the E.U.
Memor is a trademark of Datalogic S.p.A. and/or its affiliates. All other
brand and product names may be trademarks of their respective owners.
Patents
See www.patents.datalogic.com for
patent list.
Support Through the Website
Datalogic provides several services as well as technical support through its
website. Log on to www.datalogic.com.
For quick access, from the home page click on the search icon , and type in
the name of the product you’re looking for. This allows you access to download
Data Sheets, Manuals, Software & Utilities, and Drawings.
Hover over the Support & Service menu for access to Services and Technical
Support.
Warranty Terms and Conditions
The warranty period is 1 year for the device and 90 days for consumables (e.g.
battery, power supply, cable etc.) from date of purchase at our company.
See the Safety & Regulatory Addendum included with your product for additional
regulatory, safety and legal information.
©2022 Datalogic S.p.A. and/or its affiliates. All rights reserved. Datalogic
and the Datalogic logo are registered trademarks of Datalogic S.p.A. in many
countries, including the U.S. and the E.U.
822004480 (Rev. A) May 2022
www.datalogic.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>