MEMOR™ 10
SAFETY & REGULATORY
ADDENDUM DOCK, SINGLE SLOT, MEMOR 10
MODEL: DL36SSD

©2022 Datalogic S.p.A. and/or its affiliates  All rights reserved  Without limiting the rights under copyright, no part of this documentation may be reproduced, stored in or introduced into a retrieval system, or transmitted in any form or by any means, or for any purpose, without the express written permission of Datalogic S.p.A. and/or its affiliates • Datalogic and the Datalogic logo are registered trademarks of Datalogic S.p.A. in many countries, including the U.S. and the E.U.

This document is an addendum to the Quick Start Guide (QSG) for this product.
See the QSG for additional product information.

www.datalogic.com

NOTE: Read carefully the dock 10 Quick Start Guide before performing any type of connection to the dock. The user is responsible for any damage caused by incorrect use of the equipment or by the inobservance of the indication supplied in the user manual.

GENERAL SAFETY RULES

CAUTION:

• Before using the dock, read this Addendum carefully.
• Before using the dock devices and battery packs, read also the MEMOR 10 Safety & Regulatory Addendum.
• Use only the components and accessories supplied by the manufacturer for the specific dock being used.
• Do not attempt to disassemble the dock as it does not contain parts that can be repaired by the user. Any tampering will invalidate the warranty.
• Do not submerge the dock in liquid products.
• For further information or support, refer to the Datalogic website: www.datalogic.com.

CAUTION: Do not put any foreign objects such as, but not limited to, coins, paper clips, or stickers inside the slot of the dock (see the examples below).

NOTE: The dock gets warm during charging; this is normal and does not mean a malfunction.

POWER SUPPLY
The device is intended to be supplied by a UL Listed/CSA Certified Power Unit LPS/SELV rating 12V, min 5A power source which supplies power via the power connector of the cable.
Any changes or modifications to equipment, not expressly approved by Datalogic could void the user’s authority to operate the equipment.

REACH WARNING
WARNING:

3 Silvery metal part “Lead compound” content is > 1000ppm

5 Golden metal part “Lead compound” content is > 1000ppm

26 Golden metal pin “Lead compound” content is > 1000ppm

28 Black diode “Lead compound” content is > 1000ppm

WIRELESS AND RADIO FREQUENCIES WARNINGS

WARNING: Do not attempt to charge any other device different from the dock. Make sure there’s nothing between the charger and the device. Do not insert nor attach anything, such as stickers, inside the dock slots. Use only the supplied or an approved replacement antenna. Unauthorized antennas, modifications or attachments could damage the product and may violate laws and regulations. Most modern electronic equipment is shielded from RF signals. However, certain electronic equipment may not be shielded against the RF signals generated by the dock. Datalogic recommends persons with pacemakers or other medical devices to follow the same recommendations provided by Health Industry Manufacturers Associations for mobile computers. Persons with pacemakers should ALWAYS keep this device more than twenty-five (25) cm from their pacemaker and/or any other medical device. Do not install the dock in any area with a potentially explosive atmosphere. Observe restrictions and follow closely any laws, regulations, warnings, and best practices on the use of radio equipment near fuel storage areas or fuel distribution areas, chemical plants, or where any operation involves the use of explosive materials. Do not store or carry flammable liquids, explosive gases or materials with the device or its parts or accessories. Areas with a potentially explosive atmosphere are often, but not always, clearly marked or shown. Sparks in such areas could cause an explosion or fire, resulting in injury or even death. This product may cause interference to radio equipment and should not be installed near maritime safety communications equipment or other critical navigation or communication equipment operating between 0.4530 MHz.

EUROPEAN DECLARATION OF CONFORMITY
Hereby, Datalogic S.r.l. declares that this radio equipment is in compliance with Directive 2014/53/ EU. The full text of the EU declaration of conformity is available at:  www.datalogic.com. Select the Support & Service > Downloads > Product Certifications link where you can search for your specific product certification.

UKCA DECLARATION OF CONFORMITY

Hereby, Datalogic S.r.l. declares that the full text of the UKCA Declaration of Conformity is available at: www.datalogic.com. Select the Support & Service >Downloads > Product Certifications link where you can search for your specific product certification.

INFORMATION FOR THE USER

Contact the competent authority responsible for the management of radio frequency devices of your country to verify any possible restrictions or licenses required.

FCC SUPPLIER’S DECLARATION OF CONFORMITY

This device complies with part 18 of the FCC Rules.
Supplier’s Name: Datalogic USA
Supplier’s Address(USA): 959 Terry Street, Eugene, OR 97 402 USA
Supplier’s phone number: 541-302-4084
FAX: 541-345-7140
E-mail: ken.wyman@datalogic.com.

Notice:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired operation.
Note:
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FCC RF Exposure Warning
In order to comply with FCC RF Exposure requirements, this device must be installed to provide at least 15 cm separation from the human body at all times.

IT COMPLIANCE

NOTICE:
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.

RADIOFREQUENCY RADIATION EXPOSURE INFORMATION
This device was tested for E field and H field to demonstrate compliance with RF exposure limit, according to international Standards covering human exposure to electromagnetic fields from radio devices. More information about the relevant Standards for RF exposure measurement methods and procedures may be found in the CE DoC included in the product user manual available at http://www.datalogic.com website. This device is compliant with RF exposure limits for general population/uncontrolled exposure specified in Council Recommendation 1999/519/EC Annex II.

RADIO TECHNOLOGIES AND FREQUENCY BANDS
The dock incorporates the following radio technologies and supports the corresponding frequencies, as specified below:

**** CAUTION: Don’t place any metal object between the TX surface and RX surface, otherwise the metal objects will be heated, and therefore the temperature might get high.

**** CAUTION: The product wireless conducted power follows all related RF standards. Any change in the product voltage and temperature or any abnormal operating method might make product wireless conducted power unstable, thus impacting product performance.

R-R-DLs-DL36SSD

Datalogic S.r.l.
Via San Vitalino 13
40012 Calderara di Reno (BO) Italy
Tel. +39 051 3147011
Fax +39 051 3147205

©2022 Datalogic S.p.A. and/or its affiliates
All rights reserved. Without limiting the rights under copyright, no part of this documentation may be reproduced, stored in, or introduced into a retrieval system, or transmitted in any form or by any means, or for any purpose, without the express written permission of Datalogic S.p.A. and/or its affiliates. Owners of Datalogic products are hereby granted a non-exclusive, revocable license to reproduce and transmit this documentation for the purchaser’s own internal business purposes. Purchaser shall not remove or alter any proprietary notices, including copyright notices, contained in this documentation and shall ensure that all notices appear on any reproductions of the documentation. Electronic versions of this document may be downloaded from the Datalogic website (www.datalogic.com). If you visit our website and would like to make comments or suggestions about this or other Datalogic publications, please let us know via the “Contact” page.

Disclaimer
Datalogic has taken reasonable measures to provide information in this manual that is complete and accurate, however, Datalogic shall not be liable for technical or editorial errors or omissions contained herein, nor for incidental or consequential damages resulting from the use of this material. Datalogicreserves the right to change any specification at any time without prior notice.

Trademarks
Datalogic and the Datalogic logo are registered trademarks of Datalogic S.p.A. in many countries, including the U.S.A. and the E.U.
Memor is a trademark of Datalogic S.p.A. and/or its affiliates. All other trademarks and brands are property of their respective owners.
Country of Origin: China.

WEEE STATEMENT

Waste Electrical and Electronic Equipment (WEEE) Statement
For information about the disposal of Waste Electrical and Electronic Equipment (WEEE), please refer to the website at www.datalogic.com.

References

• Datalogic | Automatic Data Capture and Process Automation - Datalogic
• Datalogic | Automatic Data Capture and Industrial Automation - Datalogic

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>