SCANSTRUT SC-CW-6GT Waterproof Wireless Charger Installation Guide

Table of Contents

SCANSTRUT-SC-CW-6GT-Waterproof-Wireless-Charger-product -
Copy

Product Name: Waterproof Wireless Charger Nest 3 Coil 15W SC-CW-6GT
Model: 10-05-2024 (Rev A)
IP Waterproof Rating: IPX6 Front and back
Input Voltage: 10-30V DC (12/24V System)
Input Current Max : 2A
Output Power Max : 15W (9V 1.25A)
Standby Power Max : 12mm x M3 Countersunk Bolt with washer and Nyloc (Not included)
Certification: LED Charging indicator – White LED Constant: ON
Charge, Red LED Constant: Standby (power ON), Red LED Flashing: Foreign object detection, Thermal cutout

Installation Instructions:

Gather the part list including countersunk pocket, screws, bezel, pan head screws.
Use tools required such as Jig Saw, Pozi screwdriver, and sealant for installation.
Optionally, use drainage if needed.
Follow the technical specifications for installation ensuring proper voltage and current.

LED Indicator:

White LED Constant: Indicates charging is in progress.
Red LED Constant: Indicates standby mode (power ON).
Red LED Flashing: Indicates foreign object detection or thermal cutout. Remove metallic objects or wait for the product to return to operating temperature.

Contact Information
For further installation and warranty information, visit the official website or contact customer support.

Cut out template
Mark the cutting boundary
Use template to
- Drill 4x pilot holes (see table)
- Hole saw 2x
- Hole saw 2x
Jig saw inside of the cutting boundary. DO NOT exceed the boundary area.
Apply silicone sealant generously around the flange, ensuring good coverage around the perimeter.
(Optional – Tools and parts not included).
Install drainage on the product.
- Drain holes: Ø5mm (0.2″) drill bit required.
- Drain pipe: ID Ø8mm (5/16″) required.
- Secure pocket in place using 4x countersunk fixings.
- Apply silicone sealent to fixing holes.
- Attach front bezel.
- Secure in place using 2x pan head fixings.
- Connect wires or connectors to 12/24V supply, ensuring a waterproof connection.
- Fuse according to input voltage and current.

Note : The electrical schematic is to illustrate how theproduct should be connected to a 12V DC or 24V DC battery/power supply.

SCANSTRUT-SC-CW-6GT-Waterproof-Wireless-Charger-fig-9

SCANSTRUT-SC-CW-6GT-Waterproof-Wireless-Charger-
fig-9

White LED Constant: ON Charge
Red LED Constant: Standby (power ON)
Red LED Flashing:
Foreign object detection: a metallic object placed on top that is not Qi compatible.
OR

Thermal cutout: The internal temperature is too high/ low. Wait for the product to return to operating temperature.

For further installation and warranty information please visit: www.scanstrut.com

USA

Q: What does the red flashing LED indicate?
- A: The red flashing LED indicates either foreign object detection (metallic object placed on top that is not Qi compatible) or thermal cutout due to high/low internal temperature. Wait for the product to return to operating temperature.
Q: Can I use a different bolt than the one specified in the specifications?
- A: It is recommended to use the specified 12mm x M3 Countersunk Bolt with washer and Nyloc for optimal performance and safety.