SCANSTRUT SC-USB-01 USB Charge Power Boat Instruction Manual
- October 30, 2023
- SCANSTRUT
Table of Contents
SC-USB-01
Installation Instructions
Part List
Tools Required
-
Use the gasket as a template to mark the hole centres.
-
Drill mounting holes (see tools required).
-
– Stick Gasket down
– Tighten lock ring onto product until securely fi xed
– Screw product into position.
-
Connect to 12/24V supply, ensuring a waterproof connection. Fuse and select cable diameter according to input voltage and current for your specifi c installation.
Technical information
Input voltage
12/24V System| 10-30V DC
---|---
Input current Max| 1.5A
Output Type A| 5V —1A
Output Type A| 5V-2.1A
Total Output Current| 3.1A
Standby draw| 0.01W
Waterproof rating| IPX4
Certification| CE, ROHS
READ IMPORTANT SAFETY INFORMATION BEFORE INSTALLING.
WARNING:
This product is to be connected to a 12V DC or 24V DC battery power source
only. The power supply must be switched off before installation.
An appropriate fuse or circuit breaker must be used between the battery /
power source and this product. Check for correct polarity of all wiring before
switching the power on.
This product may contain high voltages. Do not tamper with the product.
This product is NOT approved for use in hazardous/flammable atmospheres.
Do NOT install in a hazardous/flammable atmosphere e.g. engine room.
Before drilling any holes, ensure the area behind the mounting location is
clear of wires, fuel and all other hazardous objects.
Ensure any holes cut will not significantly weaken the structure of the
mounting surface.
If the product needs to be mounted outside, it must be mounted in a location
safely above the waterline, where it is not at risk of being submerged.
CAUTION:
This product does not contain any user serviceable parts. DO NOT attempt to
repair or modify the product in any way.
When used in high ambient temperature or in direct sunlight, the product may
turn off temporarily, this is a safety feature of the electronics.
The IP protection rating is only valid if the installation is carried out
correctly according to the instructions and on a perfectly flat, smooth and
non-porous surface.
When choosing a mounting location, avoid areas exposed to heat radiation
devices and areas with poor ventilation
WIRING:
Professional electrician installation recommended, see Technical Information
for power requirements.
To achieve max power output, the specified voltage must be at the charger.
Battery performance and voltage drop needs to be considered for installation.
ENVIRONMENTAL PROTECTION:
Waste electrical products should not be disposed of with household waste.
Please recycle where facilities exist. Check with your Local Authority or
retailer for recycling advice.
IMPORTANT:
Scanstrut Ltd & Inc. accepts no responsibility for any injuries or other
damages arising from the use of their products in any circumstances.
WARRANTY:
A 2 year, non-transferable warranty covers this Scanstrut product only and not
any devices that are charged by it. No warranty is given for users’ devices
and users expose their devices to hazards, known or unknown, at their own
risk.
Cutting Template 1:1 Scale
Print document 1:1
Scale for correct cutting template size.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>