SCANSTRUT PTM-R1-S40 Tapered Radar Mast Instruction Manual
- June 1, 2024
- SCANSTRUT
Table of Contents
SCANSTRUT PTM-R1-S40 Tapered Radar Mast
Specifications
- Model : TAPERED RADAR MAST PTM-R1-S40 and PTM-R2-S40
- Part List : PTM-1-S40 only
- Tools Required : Pozi and flat head screwdriver, Hole saw suitable for cable routing, Spanner 13mm x 1, 10mm x 2
Product Usage Instructions
Installation Instructions
To install the TAPERED RADAR MAST PTM-R1-S40 and PTM-R2-S40, follow these steps:
- Attach the PTM-R-S40 Taper mast to the mounting plate DPT-R-PLATE-02 using the provided M6x20 Hex Head bolts, M6 Washers, and M6 Nuts.
- Mount the PTM Wing LH and PTM Wing RH on either side using the included hardware.
- Secure the Cover plates using the provided M5 Shoulder Washers and M5x10mm Pan Head screws.
- Complete the assembly by attaching the Base seal and Tube caps as per the manual instructions.
FLIR M100/200 Riser Kit Assembly
If you are using the FLIR M100/200 riser kit, follow these additional steps:
- Attach the M100-200 plate to the mast using the specified hardware.
- Install the riser kit components using the provided bolts, washers, and nuts.
Important Notes
Ensure that the installation is done correctly to avoid damage. Regularly inspect for loose parts or damage. The product is designed for approved marine electronics under normal boating conditions.
FAQ
- Q: What tools are required for installation?
- A: You will need a Pozi and flat head screwdriver, a hole saw suitable for cable routing, and spanners of sizes 13mm x 1 and 10mm x 2.
- Q: What should I do if I encounter loose parts during assembly?
- A : Stop the assembly process immediately and tighten any loose parts. Ensure all components are securely attached before proceeding with installation.
Installation Instructions
Part List
FLIR M100/200 riser kit
FLIR M100/200 riser kit
Parts not supplied
Tools Required
IMPORTANT
No liability is accepted for damage caused by incorrect installation. The
installation and assembly must be regularly inspected for evidence of damage
or loose parts.
Product has been designed specifically for the mounting of approved marine
electronics under normal boating conditions.
UK & International
- +44 (0)1392531280
- sales@scanstrut.com
For further installation and warranty information please visit:
USA
- +1 860 308 1416
- usasales@scanstrut.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>