SCANSTRUT PTM-R1-1 Tapered Radar Mast Installation Guide
- June 1, 2024
- SCANSTRUT
Table of Contents
SCANSTRUT PTM-R1-1 Tapered Radar Mast
Specifications:
- Product Name: Tapered Radar Mast PTM-R1-1 and PTM-R1-2
- Part List:
- PTM-R1-1 only
- PTM-R1-2 only
Product Usage Instructions
Installation Instructions:
Ensure you have all the parts listed in the part list for the specific model you have (PTM-R1-1 or PTM-R1-2).
Tools Required:
- Pozi and flat head screwdriver
- Hole saw suitable for cable routing
- Spanner 13mm x 1, 10mm x 2
- No. 5 Allen key
Riser Kit Assembly:
- Assemble the FLIR M100/200 riser kit by following the provided instructions.
- Secure the riser kit using the specified bolts, washers, and nuts.
Important Notes:
No liability is accepted for damage caused by incorrect installation. Regularly inspect the installation for any signs of damage or loose parts. The product is designed for mounting approved marine electronics under normal boating conditions.
FAQ:
-
Q: What should I do if I’m missing parts?
A: Contact customer support at +44 (0)1392531280 or usasales@scanstrut.com for assistance. -
Q: Can I use this product for non-marine applications?
A: The product is specifically designed for marine electronics mounting under normal boating conditions.
Part List
FLIR M100/200 riser kit
Parts not supplied
Tools Required
Riser kit only
Installation Instructions
IMPORTANT
- No liability is accepted for damage caused by incorrect installation.
- The installation and assembly must be regularly inspected for evidence of damage or loose parts.
Product has been designed specifically for the mounting of approved marine electronics under normal boating conditions