3 LEGGED THING Z8 Dedicated for the Nikon Instruction Manual
- September 11, 2024
- 3 Legged Thing
Table of Contents
3 LEGGED THING Z8 Dedicated for the Nikon
IMPORTANT
DO NOT USE YOUR L-BRACKET UNTIL YOU HAVE READ THESE INSTRUCTIONS. NO WARRANTY
CLAIM WILL BE ENTERED INTO FOR THE MISUSE OR INCORRECT USE OF THESE PRODUCTS.
- Look at your box.
- See that little sticker with a serial number and a barcode? Peel it off and put it here for safe keeping Or don’t.
Product Overview
- Base Plate
- Upright
- Cut-out for camera strap lug
- Open aspect for cable access
- ¼”-20 stainless steel mounting screw
- Weight-saving cut out in base
- Peak Design Capture v3 Adapter Plate with longer 1/4”-20 screw
- Toolz Multi Tool
- QD Socket – Only for QD accessories
- Dual 1⁄4”-20 & 3/8”-16 thread in base plate for attachment of accessories
- 1/4”-20 accessory thread
Installation Instructions
Attachment of PD adapter plate
To fit the Peak Design Capture v3 adapter plate to the bracket, simply remove
the 1/4”-20 from the camera(1), slot in the longer 1/4”-20 screw through the
PD plate (2) and line-up the small pin hole with the 1/4”-20 thread (3). The
PD plate will simply slot into place and then you can tighten this onto your
camera (4).
Warranty Information
Your 3LT product comes with a 5 Year Global Warranty. On the box you will find a sticker with a unique serial number and QR code. Use this serial number to register your products at www.3leggedthing.com/register
Details of your warranty can be found at
www.3leggedthing.com/faq
Your warranty covers 3 Legged Thing products only. If you have a question or
suspect you have a fault, contact us first at
www.3leggedthing.com/support
Unit 2A Kinsbourne Farm
Bury End
Stagsden
Bedfordshire
MK43 8TS
United Kingdom of Fadeless Splendour.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>