SIGMA RL 150 Flashing Rear Light with Brake Light Instruction Manual
- June 3, 2024
- SIGMA
Table of Contents
SIGMA RL 150 Flashing Rear Light with Brake Light
ACCESSORIES
WARNING
Possibly dangerous optical radiation! Never look directly into the lamp or
point it at other people‘s eyes while it is in operation.
ALIGNMENT
The final side of the tail lamp is perpendicular to the roadway and at right
angles to the vehicle center axis.
5 MODES
MODE MEMORY FUNCTION
CALIBRATING THE BRAKE LIGHT
BATTERY INDICATOR
NOTE: If the battery capacity is less than 20 %, the red indicator LED lights up and after about 45 minutes, the red LED begins flashing, and the BUSTER RL 150 goes out completely shortly thereafter.
CHARGING
The lamp needs to be charged at room temperature. (Charging temperature: +10
°C to +45 °C) (50 °F to 110 °F) (Ladetemperatur: +10 °C bis +45 °C) Ensure
that the USB sealing marked red is always closed correctly after charging.
CHARGING INDICATOR
TECHNICAL DATA
- Charging Temperature: +10°C to +45°C (50 °F and 110 °F)
- Battery Type: 3.7 V 680 mAh
- Max power: 1W
- Water and Dust rating: IP44
FCC DECLARATION OF CONFORMITY
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation. The grantee is not responsible for any changes or modifi cations not expressly approved by the party responsible for compliance. Such modifi cations could void the user’s authority to operate the equipment.
This equipment should be installed and operated with a minimum distance of 5
millimeters between the radiator and your body.
NOTE:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution
Any changes or modifi cations not expressly approved by the party responsible
for compliance could void the user’s authority to operate this equipment.
Radiation Exposure Statement
The product complies with the FCC portable RF exposure limit set forth for an
uncontrolled environment and is safe for intended operation as described in
this manual. Further RF exposure reduction can be achieved if the product can
be kept as far as possible from the user body or set the device to lower
output power if such a function is available.
SIGMA-ELEKTRO GmbH
Dr.-Julius-Leber-Straße 15 67433 Neustadt / Weinstraße Germany
Tel. +49 6321-9120-118
kundenservice@sigmasport.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>