SIGMA ENGINEERED SOLUTIONS INS-UCBX-DPXKIT Duplex Receptacle Kit Instruction Manual
- June 3, 2024
- SIGMA ENGINEERED SOLUTIONS
Table of Contents
SIGMA ENGINEERED SOLUTIONS INS-UCBX-DPXKIT Duplex Receptacle Kit
PACKAGE CONTENTS :
BEFORE STARTING:
WARNING: Improper wiring of any electrical device can cause serious injury or death. These wiring devices should only be installed by a certified electrician or other qualified person.
CAUTION: This product should be installed in accordance with the National Electrical Code and all applicable local codes and standards.
TURN OFF POWER BEFORE INSTALLING.
Use only copper wire
INSTALLATION OF OUTLET BOX:
- For wall mounting, fasten mounting lugs to box in desired orientation using provided screws (Fig. 1).
- Pull power supply wires into box, securing with appropriate fitting.
- Mount box to wall using 1” long screws (not included) that are appropriate for the wall material.
- Close any remaining holes with enclosed plugs and use a silicone sealing compound for wet location installation.
INSTALLATION OF DEVICE and COVER:
- Refer to included receptacle manufacturer’s instructions for receptacle wiring.
- Ensure box is grounded using green ground screw.
- Remove tear-outs from gasket as required to fit duplex device.
- Remove the screws from the receptacle.
- Using these screws, mount cover, gasket and receptacle to outlet box with the hinge at the top (Fig. 2)
Tip: Insert and hand tighten the bottom screw first, followed by the top
screw.
Then tighten both screws with a screwdriver.
NOTE
Manufacturer’s instructions and wiring diagram supplied with Receptacle.
Please read completely before installation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>