Nathan James 74501 Logan Modern Rattan TV Stand Entertainment Cabinet User Guide
- September 7, 2024
- NATHAN JAMES
Table of Contents
74501 Logan Modern Rattan TV Stand Entertainment Cabinet
“`html
Product Specifications:
-
Product Name: Furniture Tipping Restraint for Sideboard Class
High -
Recommended Use: To prevent tipping of furniture, especially in
households with young children -
Components Included: 2 plastic straps, 4 screws, 2 nylon wall
plugs, 4 metal brackets
Product Usage Instructions:
Installation:
-
Attach one mounting bracket near the top back edge of the
furniture using a screw. -
Mark the position on the wall below the bracket mounted on the
furniture. -
If a wall stud is available, drill a starter hole into it. If
not, drill a hole in the wall and insert a plastic anchor. -
Attach the second bracket securely to the wall.
-
Align the two brackets.
-
Thread the strap through both brackets and tighten until
snug. -
Ensure both brackets are firmly installed and the strap is
secure.
Frequently Asked Questions (FAQ):
Q: Is this product a substitute for adult supervision?
A: No, this product is a deterrent and not a replacement for
proper adult supervision.
Q: Can this restraint be used on all types of furniture?
A: While it is designed for sideboards, it can be used on other
furniture pieces that pose a tipping risk to ensure stability.
“`
GH
01
FURNITURE TIPPING RESTRAINT FOR SIDEBOARD CLASS HIGH
Young children may be injured by tipping furniture and the use of a tipping
restraint is highly recommended.
When properly installed, this restraint could provide protection against the
unexpected tipping of furniture due to small tremors, bumps or climbing. We
recommend mounting this restraint to a wall stud.
WARNING: This product is only a deterrent. It is not a substitute for proper
adult supervision.
TIPPING KIT CHECK LIST
CODE COMPONENT
QTY
01 PLASTIC STRAP
2
02 SCREW
4
03 NYLON WALL PLUG 2
04 METAL BRACKET
4
Installation Instruction:
1. Attach one of the mounting brackets securely near the top back edge of the
furniture piece by inserting the screw. Refer to picture A.
2. Determine the final position of the furniture piece. Mark location on the
wall approximately 2″ below the bracket mounted to the back of the furniture.
3. Drill a starter hole into the wall stud. If wall stud is not available,
drill a hole into the wall and insert plastic anchor. Gently tap anchor until
the flange of the anchor is flush with the wall.
4. Attach the second bracket by inserting and securing the screw to the wall.
Refer to picture B.
5. Align the two brackets.
6. Thread the strap through both brackets and tighten until snug.
7. Check to make sure that the brackets are firmly installed the strap is
secure.
B
A
03 04 02
THE WALL 01
BACK SIDE
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>