alandental Macro Dental SLR Camera Installation Guide

: September 6, 2024
: Alandental

Table of Contents

Macro Dental SLR Camera
Specifications:
Product Usage Instructions:
1. Installing the Light Splitter Tube:
2. Installing the Camera:
3. Installing the Shutter Sensor:
4. Powering On:
- Frequently Asked Questions (FAQ):
Q: How do I know if the shutter sensor is working

Macro Dental SLR Camera

“`html

Specifications:

Product: alandental.com Camera
Components: Binocular tube, Light splitter tube, Camera,
Shutter sensor
Connectivity: HDMI OUT, Power

Product Usage Instructions:

1. Installing the Light Splitter Tube:

Securely lift a binocular tube up.
Loosen the screw on the light splitter tube.
Install the binocular tube to the light splitter tube and
tighten screws after adjusting its position.

2. Installing the Camera:

Attach the camera to the light splitter tube, aiming at snap
points.
Rotate the camera until you hear a sound indicating successful
installation.

3. Installing the Shutter Sensor:

Connect one side of the shutter controller cable to the shutter
sensor.
Connect the other side of the cable to the camera.
Rotate the sensor nut clockwise to secure the sensor on the
camera.

4. Powering On:

After installing the camera, connect an HD plug to the HDMI OUT
port of the camera and connect the power source.

Note: Refer to the corresponding instruction
manual for further camera adjustments and usage.

Frequently Asked Questions (FAQ):

Q: How do I know if the shutter sensor is working

correctly?

A: Press the sensor switch for 2 seconds. If the sensor light
illuminates once every 2 seconds, it indicates that the sensor is
operational. Pressing the sensor switch again for 2 seconds and
observing 4 flashes of the sensor light confirms that the sensor is
off.

“`

alandental.com Camera installation instructions

Install the light spltter tube

V
sLcoroeswenanthde lift a binocular tube up
Loosen the screw

Install a binocular tube to the light splitter tube and tighten
V screws after adjusting position

¥ Install the light splitter tube to main seat and tighten screws after adjusting position

Install a binocular tube and tighten screws

Install a canera
Install a camera to the light splitter tube (Aim at snap points when the camera install to a snap joint and then rotate a camera untill hear a sound of “ka” a camera installation is ok

alandental.com Install a shutter sensor

Connect a one side of shutter

Shutter controler

Cable of camera

C::V cable to shutter
sensor

Sensors switch Shutter sensors

Sensor nut

sCiodnenoefcsthoutthteerr ccaabmleertao a

@JJ,.
C__-;-V-;,

Sensor light

Connect a sensor to a camera, rotate clockwise a sensor nut to fix a sensor on a camera Pressing a sensor switch 2seconds and then sensor light will light once every 2seconds, it represents a sensor working; Pressing a sensor switch 2 seconds again and then a sensor light flash 4 times, it represents a sensor off.
-1 –

After installing a camera connect a HD plug to HDMI OUT of a camera and connect a power
Note:Please refer to the corresponding instruction manual for the adjustment and use of the camera.
– 2-