Alandental TR-DOM01 Dental Surgical Microscope User Guide

: June 26, 2024
: Alandental

Microscope Specification
Dental stereo microscope instructions

(This manual describes in detail the installation method of the dental microscope. Instructions for use and maintenance and care, please read the instructions carefully before use.)

Cautions

Operation

DO NOT exposed to sunlight. Should be placed in a dry, clean environment, avoid high temperatures and severe vibration.
The microscope is a precision instrument and should be handled carefully to avoid shocks and collisions during transportation.
DO NOT leave dirt or fingerprints on the surface of the lens, so as not to affect the clarity of the image.

Maintenance

All lenses should be kept clean. If there is any fine dust, blow it off with a blower or gently wipe off the cotton yarn. If there are traces of oil and fingers, use a small amount of cotton yarn with a 3:7 ratio of ethyl alcohol and ether to gently wipe off.
Do not use organic solvents to wipe the surface of the microscope, especially the surface of plastics, and use neutral detergents for cleaning.
Do not disassemble the microscope by yourself so as not to affect the performance of the microscope
Do not touch dust, cover it with a dust cover, store it in a place away from moisture, so as not to rust or mold, when the microscope is not in use.
To maintain the performance of the microscope, regular inspections are recommended.

Part Names and Functions

Parts Function Diagram

Eyepieces, objectives, light source, fine focus,
power supply box, 250° rotation, 360° rotation,
360° adjustment, power cord, 80cm, 33cm,
32cm, 38.5x33cm, 34x22cm, 42x36cm

Installation Instructions

Step 1

Screw on the picture and tighten.

Step 2

The elastic arm is inserted into the metal fixing ring.
Remember that there is a side with +/- adjustment of elasticity!
Then use the Allen screws to tighten as shown below.

Step 3

Insert one end of the large port of the power box with robotic arm The elastic arm is then tightened with the Allen screw.

Step 4

Insert short metal arm and tighten it.

Step 5

Put in the sleeve, set it to the end, tighten the screws, and remember to tighten.

Step 6

Plug the power cord into the flashlight port.

Step 7

Insert the flashlight and screw down the small screws below.

Installation Method

The normal use of the instrument room temperature +5 ° – + 40 ° , the power cord is plugged into the power grid, power switch to “NO” position.
Home, irradiation light is on. Place the object under observation at the center of the objective lens, hold the robotic arm and move up and down.
Micromirror, so that the observed object is at the working distance (about 230mm), then slowly turn the focusing handwheel,
Makes the right eyepiece observe a clear object image; then observe the left eyepiece, if the object is not clear, adjust the viewing tube.
Circle, so that it can get a clear image, and then turn the left and right eyepiece tube, so that the two objectives of the exit distance and operation of the pupil.
The viewer’s eyesight is appropriate, so that you can see a clear, three-dimensional image.

Configuration List

1,Microscope section: eyepiece 10X (optional 20X), objective lens lx.
2, the microscope arm bending: three angles can rotate arm angle.
3, Worktable: total height 80CM, upper disk 38.5CM33CM, middle disk 34CM22CM,Lower disk 42CM*36CM.