DIRT KING DK-SW001 2.0 IFP Tundra Coilovers Pair Installation Guide
- September 4, 2024
- DIRT KING
Table of Contents
DIRT KING DK-SW001 2.0 IFP Tundra Coilovers Pair
Installation Instructions
- Front IFP Shocks
- DK-815985F
- Page 1 of 2
Parts Included
Please check that all items are present before installation. If for any reason, there is an item or items missing send an email to sales@dirtking.com with proof of purchase and a picture of parts received.
Before install ling, read all instructions. Only certified mechanics should install Dirt King products. Mandatory wheel alignment and ADAS ca liberation at certified facilities are required after suspension modifications. Failure to do so can lead to handling problems and safety risks. Dirt King is not responsible for damages from improper installation or misuse. Adhere to your vehicle manufacturer’s recommendations. For more information, visit https://dirtking.com/pages/disclaimer
Step 1: Disassembly
Start by raising the vehicle and placing jack stands under the frame rails.
Next remove the front wheels. Disconnect the brake hose bracket and wheel
speed sensor to prevent damage during shock removal. Loosen the upper control
arm ball joint nut. Strike the side of the knuckle to loosen the ball joint
tape r (Image 1). Rotate the upper control arm upward. Remove the sway bar
link nut from lower control arm (Image 2). Note: Aftermarket upper control
arms are required with these shocks. Remove the upper and lower shock bolts.
Now remove the shock from the vehicle.
Step 2: Assembly
Install the Dirt King shock by lowering the bottom mount into position. NOTE:
If you are not using Dirt King lower control arms, you will need to grind the
factory lower control arms to ensure proper clearance between the shock eyelet
and the mounting pocket (Image 3 & 4). Apply blue thread locker and torque
lower shock bolts to 114ft lbs. Align the top of shock to the coil bucket.
Apply blue thread locker to the top shock mounting bolts and torque to 35ft
lbs. Insert the upper arm ball joint into the knuckle and torque to
manufacturer’s specs. Lastly install the sway bar link using the OE hardware
and torque to 89ft lbs.
PHONE: 619-944-8913
EMAIL: SALES@DIRTKING.COM
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>