CADDXFPV gofilm 20 4K Starlight Drone User Guide
- June 8, 2024
- CADDXFPV
Table of Contents
CADDXFPV gofilm 20 4K Starlight Drone
How to bind VTX:
- Connect the moonlight kit and the power of the goggles.
- Short press the moonlight kit and goggles linking buttons respectively, when the moonlight kit enters the pairing state The VTX LED turns red, and the end of the goggles is a DI … DI … DI …
- After the link is successful, the indicator light on the VTX LED turns solid green, the beeping sound on the goggles stops and the screen is displayed.
For more information on how to use the MOONLIGHT KIT, please scan the QR code to view the electronic manual.
ARM & Mode:
After the binding is successful, use FC to connect to the Beta-fight, and enter the Modes tab. Try to toggle the corresponding switch for each function, You move the Yellow cursor of the corresponding aux channel of the switch, the corresponding function will be turned on when you move to the set range.
How to bind ELRS 2.4G
- The flight controller has a built-in ELRS receiver. Use the battery to quickly power up the Go-film 20 three times. When the receiver indicator (as shown in Figure 3) turns red and flashes twice quickly, it enters the binding mode.
- Use the ELRS 2.4G protocol remote controller for frequency binding. Take the Radiomaster ZORRO ELRS 2.4G remote controller settings as an example. Perform the remote controller settings according to Figures CD (2). After the frequency binding is successful, the flight control ELRS receiver indicator light will be solid red.
Pre-flight Check
- Turn on the transmitter and select the correct mode. Please confirm that the arming switch on the transmitter is in the “disarmed” position and the throttle is all the way down.
- Check whether the propeller steering is correct, whether the rotation is smooth, and whether the screws are locked.
- Check whether the battery power is sufficient. The 4S battery is fully charged at 16.SV.
- Please confirm the battery is securely attached to the aircraft by the strap. And secure the balance head so that it can’t be struck by the props.
- Observe whether the take-off environment is safe, whether there are obstacles, and whether it is in a no-fly zone.
- Verify that you have clean, strong video in your Fpv goggles or screen. if you see interference or you see another pilot feed, resolve this issue before flying.
CAUTION!
- This product is NOT a toy, thus it is not suited for children under 14 years of age. Minors should be accompanied by an adult when operating.
- Warnings listed in the instructions must be read carefully.
- Improper adjustments and operation will result in crashes and damage to the item.
- Experience is required before handling this product.
CADDXFPV Support
email: support@caddxfpv.com
This content is subject to change.Download the latest version from
http://www.caddxfpv.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>