Guangdong Chenyi Technology CDPE030ZCKL Electronic Door Lock Instructions
- June 5, 2024
- Guangdong Chenyi Technology
Table of Contents
Guangdong Chenyi Technology CDPE030ZCKL Electronic Door Lock Instructions
Package Contents
- Keypad
- Base plate
- Latch
- Strike plate
- Plastic box
- Hex key
- 3/4 °（19mm) Screws-4ea.
- 19/16° (30mm)Screw-2ea.
Installation and commissioning
- Punching in the door according to the dimension requirement.
- Backset is distance from door edge to Centre of hole on door face, adjust Latch fit both backset of 2 34 (70mm) or 2 38 (60mm)
- ,Select the height and backset as desired on the door face, use the Template as an indication to mark the center of the circle on the door face and the center of the door edge.
- Use the marks as a guide to drill a hole ∅2 18 (54mm) through the door face for the lockset, then a hole of ∅1 (25.4mm) for Latch.
Install Strike
Close door and mark horizontal center of Latch on to door frame. Mark vertical
line where door edge meets frame and measure in half of door thickness to find
vertical center.
Extend both lines until they intersect and drill a 1 (25.4mm)hole to 12 (15mm)
depth.
Position Strike plate and mark around edge.
Chisel farm to approx. 116 (1.6mm) depth or until Strike sits flush.
Using two wood screws fix Strike to the frame.
Installation step
Operation instructions
- Feature
- Password length 6-12 bits;
- the factory status code 123456# can open the door
- Password anti peeping function: you can add some irrelevant codes before and after the password, and then press # confirm (the maximum length is 15 digits). you can enter the password as follows: XXX password XXX #
- Low voltage prompt function: touch and light the panel when the battery voltage is lower than 4.8V, and the backlight on the screen flashes quickly 1 second. password is unlocked, the backlight on the screen will flash quickly for 1 second, and then unlock again
- When using APP to operate the door lock, most of the function operations need to be operated beside the door lock .
- The registered user for password, fingerprint on the door lock need to use the upload function in the app to see and edit them in the app
- Password input error protection function: the system will lock the password keyboard when the unlock password is input wrong 5 times in a row, and automatically unlock it after 5 minutes. During locking, app can unlock the keyboard.
- ，Restore factory settings
- Press and hold the reset button for a long time, and two “drops” will be heard. The lock will be restored to the factory settings. After the system is cleared, all the passwords added before and the phone administrator will be invalid
- When app is added to the lock, you can delete the administrate of this lock in APP (click Settings – click delete). Note: after deleting the administrator on the app, the lock will be restored to the factory settings, and all previously added passwords and mobile administrator will be invalid;
- ，Add administrator password (administrator can only be password, fingerprint and card cannot be added as administrator)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>