Eastbrook 58.716 Screen Across Bath Instruction Manual
- September 3, 2024
- Eastbrook
Table of Contents
Eastbrook 58.716 Screen Across Bath
Specifications:
- Type: Screen Across Bath
- Model Numbers: 58.716, 58.717, 58.718, 58.719
- Adjustable Width: 665-690mm, 715-740mm, 765-790mm, 845-890mm
Product Usage Instructions
Tools Required:
- Pencil
- Drill bit (6.3.2)
- Silicone & Gun
- Flat head & cross head screwdriver
- Tape measure
- Spirit level
- Drill
- Hexagon key
- Rubber hammer
Installation Steps:
-
Step 1: Preparation
Ensure you have all the required tools listed above. -
Step 2: Assembly of Front Screen
Refer to the product schematic diagram for the front screen assembly. Use the provided components A, B, C, D, E, F, G, H, I, J, K, L, M, N, O, P, and Q to assemble the front screen. -
Step 3: Assembly of Side Screen
Refer to the product schematic diagram for the side screen assembly. Use the components E, J, P, F, N, G, H, K, M, B, Q, K, A, L, C, and D to assemble the side screen. -
Step 4: Installation of Screens
Dry fit both screens for best installation tolerance to suit your bath dimensions. -
Step 5: Adjustment for Doors
Ensure correct parts are used for top and bottom of both doors. Follow the instructions in the manual for proper alignment. -
Step 6: Lubrication
If there is notable noise when the glass door moves after installation, add a small quantity of silicone lubricant onto the barrel hinge as needed.
Cleaning & Maintenance:
- Do not use irritant detergents such as alcohol or bleach for cleaning.
- Only clean with warm soapy water.
FAQ:
-
Q: What should I do if there is noise when the glass door moves?
A: Add a small quantity of silicone lubricant onto the barrel hinge. -
Q: How should I clean the shower enclosure?
A: Clean only with warm soapy water. Do not use alcohol, bleach, or other chemical cleaners.
OVERVIEW
TOOLS REQUIRED
PACKING LIST
FRONT SCREEN
SIDE SCREEN
PRODUCT SCHEMATIC DIAGRAM
SIDE SCREEN
FRONT SCREEN
INSTALLATION
- Please dry fit for best installation tolerance to suit.
- Please ensure the correct part is used for top and bottom. This process applies to both doors.
- Please dry fit for best installation tolerance to suit.
- Please ensure the correct part is used for top and bottom. This process applies to both doors.
Please ensure silicone sealant is on the outside only.
Cleaning & Maintenance
- Don’t clean the shower enclosure with an irritant detergents such as alcohol, bleach or other chemical cleaners.
- Only clean with warm soapy water.
- After the installation is completed, should you find that there is notable noise when the glass door moves, you may add a small quantity of silicone lubricant onto the barrel hinge.
Helpline: 01452 317890
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>