Eastbrook S-435 Shower Enclosure Installation Guide
- September 3, 2024
- Eastbrook
Table of Contents
Eastbrook S-435 Shower Enclosure
Specifications
- Tools Required:
- Tape measure
- Rubber hammer
- Flat and cross screwdriver
- Silicone gun
- Level ruler
- Drill machine
- Pencil
- (63.2) Bit drill
TOOLS REQUIRE
PACKING LIST
Installation Steps
- Refer to the packing list to ensure all components are available.
- Use the provided tools to assemble the shower enclosure following the diagram provided.
- Ensure all screws and parts are securely fastened.
- Check the level of the enclosure to ensure proper alignment.
- Once assembled, apply silicone sealant on the outside of the enclosure.
Cleaning & Maintenance
Do not use irritant detergents such as alcohol or bleach. Clean the shower enclosure with warm soapy water only. If there is a noticeable noise when the glass door moves, apply a small amount of lubricant to the roller wheel, slipping hook, and track. Don’t clean the shower enclosure with irritant detergents such as alcohol, bleach, or other chemical cleaners. Only clean with warm soapy water. After the installation is completed, should you find that there is notable noise when the glass door moves, you may add a small quantity of lubricant onto the roller wheel,
Helpline: 01452 317890
slipping hook and the track.
Please ensure silicone sealant is on the outside only.
FAQs
Q: What should I do if there is noise when the glass door moves?
A: Apply a small quantity of lubricant onto the roller wheel, slipping hook,
and track to reduce noise.
Q: Can I clean the shower enclosure with bleach?
A: No, do not use bleach or other chemical cleaners. Clean with warm soapy
water only.
Q: How do I contact customer support?
A: Contact our helpline at 01452 317890 for assistance.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>