NGP A605 Nylon Brush Perimeter Seals Instruction Manual
- September 3, 2024
- NGP
Table of Contents
NGP A605 Nylon Brush Perimeter Seals
Product Specifications
- Manufacturer: National Guard Products Inc.
- Phone: 1-800-647-7874
- Product Type: Nylon Brush Perimeter Seals
- Materials: Nylon brush, metal retainer
- Tested for: Positive pressure gasketing materials for fire doors
- Fire Door Ratings: Up to 3 hours for hollow-metal-type fire doors and up to 1-1/2 hours for wood-type fire doors
- Categories: H and J
Product Usage Instructions
- Remove the brush from the metal retainer.
- Cut the brush to fit the opening using pliers or diagonal cutters.
- If bristles are not secure, use a drop of adhesive to secure the brush.
- Cut the metal retainer to the required length.
- Replace the brush in the metal retainer.
- With the door closed, position the seal and mark screw holes.
- Drill pilot holes for screws using a 7/64 bit.
- Install the seal with the provided screws.
- Slightly peen the bottom end of each retainer to secure the brush from moving.
- Adjust the position so that the brush touches against the door without impeding proper closing and latching.
600, 602, A605, B606, A617, A625, A626, 672, 675, 706, 706E, 9000, 9600, 9605, 9675, 9706E
- POSITIVE PRESSURE TESTED GASKETING MATERIALS FOR FIRE DOORS
- FOR APPLICATION TO HOLLOW-METAL-TYPE FIRE DOORS
- RATED UP TO 3 HOURS AND WOOD-TYPE FIRE DOORS
- RATED UP TO 1-1/2 HOURS.
- CATEGORY H
- Smoke and Draft Control door bottom (Category H) tested to UL 1784; meets requirements of NFPA 105, IBC for use on “S” label doors. Applies to the following models: 600, 602, A605, B606, A617, A625, A626, 672, 675, 706, 706E, 9000, 9600, 9605, 9675, 9706E
601, 603, C607, D608, G610, H612, C619, F625, OV633, OV634, D648
-
POSITIVE PRESSURE TESTED GASKETING MATERIALS
-
FOR FIRE DOORS
-
FOR APPLICATION TO HOLLOW-METAL-TYPE FIRE DOORS
-
RATED UP TO 3 HOURS AND WOOD-TYPE FIRE DOORS
-
RATED UP TO 1-1/2 HOURS.
CATEGORY J
D620, G622, H623, I624
- POSITIVE PRESSURE TESTED GASKETING MATERIALS
- FOR FIRE DOORS
- FOR APPLICATION TO HOLLOW-METAL-TYPE FIRE DOORS
- RATED UP TO 3 HOURS AND WOOD-TYPE FIRE DOORS
- RATED UP TO 1 HOUR.
- CATEGORY J
Frequently Asked Questions
1. What are the fire door ratings for this product?
This product is suitable for use on hollow-metal-type fire doors rated up to 3 hours and wood-type fire doors rated up to 1-1/2 hours in Categories H and J.
How should I secure the brush if the bristles are not stable?
If the bristles are not secure, you can use a drop of adhesive to ensure the brush stays in place within the metal retainer.
Can this product be used on smoke and draft control doors?
Yes, this product can be applied to smoke and draft control doors (Category H) tested to UL 1784 and meeting NFPA 105 and IBC requirements for use on S label doors.