ZHEJIANG HFY528B Wireless Remote Control Switch User Manual
- August 30, 2024
- ZHEJIANG
Table of Contents
ZHEJIANG HFY528B Wireless Remote Control Switch
Product Information
- Product Name: Wireless Remote Control Switch
- Product Model: HFY528B
Features
- Operates through 433MHz co-frequency information transmission
- Lightly press the remote control to transmit the signal
- Requires pairing with the receiving control terminal for one-to-one control
RF Exposure Compliance: The device meets general RF exposure requirements and can be used in portable exposure conditions without restrictions.
Specifications
| Frequency: | 433MHz |
|---|---|
| Control: | One-to-one |
| Model: | HFY528B |
Product Usage Instructions
Pairing the Remote Control
- Ensure the remote control has fresh batteries.
- Locate the receiving control terminal to which you want to pair the remote.
- Press and hold the pairing button on the terminal until it enters pairing mode.
- Press any button on the remote control to transmit the pairing signal.
- Once paired successfully, test the remote control to ensure proper functionality.
Operating the Remote Control Switch
To turn the connected device on or off:
- Press the corresponding power button on the remote control.
- The signal will be transmitted to the receiver, activating or deactivating the device.
Frequently Asked Questions
-
Q: Can I use multiple remotes with one receiver?
A: No, this device operates on a one-to-one control basis, meaning each receiver can only be paired with one remote control at a time. -
Q: How far is the effective range of the remote control?
A: The effective range of the remote control is approximately XX meters under normal operating conditions.
FEATURES
- Through 433MHZ co-frequency information
- Press the remote control lightly to transmit the signal
- It needs to be paired with the receiving control terminal to realize One-to-one control
FCC
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE : This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection againstharmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception,which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>