Zhejiang General Light Curtain PEM 102 Remote Control User Manual
- June 3, 2024
- Zhejiang General Light Curtain
Table of Contents
Zhejiang General Light Curtain PEM 102 Remote Control User Manual
Product introduction
Technical data
- Power : 3V (CR2032)
- Frequency : 433.92MHz
- Working current : ≤ 20MA
- Operating temperature : – 20 ℃~+60 ℃
- Distance : ≥ 100m (open space)
Working temperature
Warning
- The remote contorl shall not be affected by moisture or impact, so as to avoid affecting its life.
- In the process of use, when you find that the remote control distance is obviously close or not sensitive, please check whether the battery needs to be replaced.
- Press any button for more than 10 seconds, and the transmitter will stop sending wireless ignals.
- Please properly dispose of the used battery according to the instructions.
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the
limitsfor a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The user that changes or modifications not expressly approved by the party responsible for compliance could void the user`s authority to operate the equipment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>