Zhejiang General Light Curtain PEM 105 Remote Control User Manual
- June 3, 2024
- Zhejiang General Light Curtain
Table of Contents
Zhejiang General Light Curtain PEM 105 Remote Control
Product introduction
Technical data
- Power : 3V (CR2032)
- Frequency: 433.92MHz
- Working current: ≤ 20MA
- Operating temperature : – 20 ℃~+60 ℃
- Distance : ≥ 100m (open space)
Warning
- The remote control shall not be affected by moisture or impact, so as to avoid affecting its life.
- In the process of use, when you find that the remote control distance is obviously close or not sensitive, please check whether the battery needs to be replaced.
- Press any button for more than 10 seconds, and the transmitter will stop sending wireless signals.
- Please properly dispose of the used battery according to the instructions.
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.Any Changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there isno guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on , the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The user that changes or modifications not expressly approved by the party responsible for compliance could void the user`s authority to operate the equipment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>