BRANDMOTION FLTW-2100 70 Inch AHD 4 Input Monitor 1080p Installation Guide
- August 28, 2024
- BRANDMOTION
Table of Contents
BRANDMOTION FLTW-2100 70 Inch AHD 4 Input Monitor 1080p Installation Guide
Recommended Tools
Zip Ties| Wire Strippers| Wire Cutters| Electrical Tape| Screw Driver| Panel
Removal Tool
---|---|---|---|---|---
| | | | |
Difficulty Level
Install Time
1hr 30m – 2hr
Questions? Call the Brand motion technical support line at 734-619-1250 or CLICK HER
Kit Contents
1x Wired Monitor
1x Fan Mount
1x 20m Camera Extension Wire
1x Monitor Harness
Mounting Monitor
**Part 1
**
- Choose a desired mounting location on the dashboard to mount the fan mount on.
- Peel off the red 3M tape cover and adhere it to the dash, then use provided screws to secure the mount more permanently.
- Slide the monitor between the bracket on the mount.
- Tighten the retaining nut against the bracket to secure monitor in place.
Wiring
**Part 2
**
- Connect the monitor harness to the monitor.
- Find Accessory power, Constant power, and Ground in the vehicle. Run leads of each towards the monitor harness.
- Connect RED to Acessory, YELLOW to Constant, and BLACK to Ground.
- By wiring the trigger wires, the monitor can automatically select appropriate inputs.
- Attach power harness to the monitor, and the camera extension wire to the desired input.
- Run the harness toward the desired camera mounting location.
Example Use Case:
Mount a Channel 2 camera on the right side of the vehicle, wire the GREEN
trigger to the right turn signal and the monitor will switch to the camera
when the turn signal is activated.
| Red | Accessory Power |
|---|---|
| Yellow | Constant Power |
| Black | Ground |
| Brown | Channel 1 Trigger |
| Green | Channel 2 Trigger |
| Blue | Channel 3 Trigger |
| Grey | Channel 4 Trigger |
DVR
**Part 3
**
- The system is capable of recording footage by inserting an SD card in the left side of the monitor.
NOTE : Only use SD cards up to 128GB.
Monitor Navigation
Part 4
| Button | Primary Function | Menu Function |
|---|---|---|
| CAM | Cycle Camera Layout | N/A |
| MENU | Open Menu | Back |
| – | Volume Down | Navigate Right |
| POWER | Display On/Of | Display On/Off |
| + | Volume Up | Navigate Left |
| ENTER | Start/Stop Recording | Scroll Up |
| CARD | View Recordings | Scroll Down |
Use Primary Function when monitor is in normal operation, Menu Function for when navigating the menu.
Camera Mounting & Power
Camera Connection
**Part 5
**
- The camera(s) will be powered via monitor harness. Connect the camera(s) to the extension harness to draw the necessary power and video signal.
Camera Compatibility
Part 6
Compatible with any 1080p AHD 4-pin camera.
See Brand motion Parts:
- FLTW-1000
- FLTW-1001
- FLTW-1002
- FLTW-1003
- FLTW-1004
- FLTW-1100
- FLTW-1101
- FLTW-1102
Vehicle Application:
Universal Vehicle Part Number : 2100