SENCOR 35057014 WH Tws Earphones User Manual
- June 1, 2024
- SENCOR
Table of Contents
SENCOR 35057014 WH Tws Earphones
Supply
content
- ‘L’ and “R” earphone
- Charging case
- User’s manual
- USB-C charging cable
SEP 540 BT Bluetooth earphones description
1 Earphone touchpad
2 Microphone and earphone charging contacts
3 Earphone LED indicator
4 Earphone charging contacts in the case
5 Charging case LED indicator
6 USB-C charging connector
R Right earphone
L left left earphone
Lift and right earphone function
- Long touch – turn off/on the earphone
- 1 x long touch (2 seconds) during an incoming call – call rejection
- 1 x short touch during an incoming call – answer the call
- 1 x short touch during an ongoing call- end call
- 1 x short touch – play function
- 1 x short touch – pause function
- 3 x short touch – launch SI RI/Google Assistant
Left earphone
- Long touch in music mode – reduce volume by one level
- 2 x short touch – previous track
Right earphone
- Long touch in music mode – increase volume by one level
- 2 x short touch – next track
Putting Into Operation
Before first use, be sure to read the safety instructions contained in this user’s manual carefully. Before using the earphones for the first time, put the earphones in the charging case and connect the charging adapter. Wait until the charging case and earphones are fully charged. Turning on the earphones – Taking the earphones out of the case will automatically switch them on. When the earphones are in the off state outside the charging case. Press and hold the touch pad on each earphone and wait for the earphones to switch on. Turning off the earphones – Inserting the earphones into the charging case will automatically turn off the earphones. Long press and hold the touch pad of the earphones until the earphones turn off. Pairing the earphones with each other – The earphones are already paired from the factory and do not need to be paired with each other. (If pairing to 1WS mode fails, return the earphones to the charging case and repeat the above instructions).
Warning: To prevent damage to your hearing, always keep the volume level
of your device to a minimum before connecting BT earphones to your mobile
device. Keep the touch pad clean and avoid touching other objects or body
parts such as hair.
Note : If the BT earphones are not paired with any device, they will turn
off when left idle for a long time. Put them in the case.
Pairing your earphones via Bluetooth
To pair the BT earphones with your mobile device, do the following:
Remove the earphones from the charging case (blue and red intermittent earphone indication) and look for the Bluetooth earphone name “SEP 540BT” in the device you want to pair and start the pairing process. Always perform the pairing process when both earphones are removed from the charging case. If you are requested to enter a pairing code while your device and the BT earphones are pairing, use the following code: “DODO”.
To cancel the pairing process, disconnect the BT earphones from your mobile device (cancel the Bluetooth pairing). Remark: To ensure a stable Bluetooth connection, make sure that the distance between the BT earphones and your paired device is kept within 10 meters. Depending on ambient interference, in some cases, it may be necessary to maintain a shorter distance between the BT earphones and the paired device.
Charging
- A charged battery provides power for several hours of operation at normal volume levels. A high volume consumes more battery power; therefore, we recommend listening at normal volume levels. When the BT earphones are placed in the charging case, the led indicators show:
- a. The blue continuous indication of the earphones indicates charging
- b. When the USB-C charging cable is connected, the intermittent orange indication shows the charging of the charging case. A fully charged charging case is indicated by an orange solid indication. Attention: For charging, use only the original accessories supplied with the appliance. To achieve maximum battery life, it is advisable to start charging the battery only when the battery is low (10% – 20%). Charge continuously until fully charged. Recommendation: If your earphones are not to be used for an extended period of time, we recommend to fully charge the batteries once every two to three months. We recommend storing the BT earphones and the charging box with the battery charged to prevent irreparable damage to the battery (loss of capacity).
Specification:
- Bluetooth Version : 5.0
- Bluetooth profile : HSP, HFP, A2DP, AVRCP
- Speaker Diameter : φ13mm X 2pcs
- Impedance : 32 Ω±10 %
- Frequency range : 20 Hz – 20 kHz
- Sensitivity: 120dB±3 dB /1 mW (S.P.Lat 1 KHz)
- Microphone Sensitivity : -38dB±3dB
- Earbud Battery: 3.N, 25mAh Li-po Battery
- Base Battery : 230mAh Li-po Battery
- Earbud Continuous Playing time: ≈3 hrs per full charged
- Charging time :≈1.5 hrs for Base,≈1.5 hrs for Earbuds
- Charging Port : Type-C
Safety Notice:
Please observe the rules of the Country or Region which you are in while
driving.
Do not disassemble or modify the headset at any reason, otherwise, It may
damage or burn the headset. If there is any quality problem, please send the
headset to the authorized service center for repair.
Please keep the equipment along with all the accessories out of the reach of
children and pets.
Extreme temperatures will cause the device deformation, reduce the charging
capacity and shorten the working life.
Please do not immerse the earphones into water. The guarantee will be lost ii
damage is caused by being immersed into water.
It will damage your hearing ii you listen with high volume for a long time. It
is recommended that only use the lowest volume which is necessary for speaking
and listening to music.
Instructions and information regarding the disposal of used packaging materials
Dispose of packaging material at a public waste disposal site.
Disposal of used electrical and electronic appliances
The meaning of the symbol on the product, its accessory or packaging indicates that this product shall not be treated as household waste. Please, dispose of this product at your applicable collection point for the recycling of electrical & electronic equipment waste. Alternatively in some states of the European Union or other European states, you may return your products to your local retailer when buying an equivalent new product. The correct disposal of this product will help save valuable natural resources and help in preventing the potential negative impact an the environment and human health, which could be caused as a result of improper liquidation at waste. Please ask your local authorities or the nearest waste collection center far further details. The improper disposal of this type of waste may fall subject ta national regulations fur fines.
For business entities in the European Union
If you wish to dispose of an electrical or electronic device, request the necessary information from your seller or supplier.
Disposal in other countries outside the European Union
If you wish to dispose of this product, request the necessary Information about the correct disposal method from local government departments or from your seller.
This appliance complies with EU rules and regulations regarding electromagnetic and electrical safety. Changes to the text, design, and technical specifications may occur without prior notice and we reserve the right to make these changes.
Hereby, FAST CR, a.s. declares that the radio equipment type SEP 540 BT is in compliance with Directive 2D14/53/EU.
The full text of the EU declaration of conformity is available at the following internet address: www.sencor.eu
Manufacturer: FAST CR, a.s. U Sanitasu 1621 25101 Ricany Czech Republic
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>