Eastbrook Freestanding Bath with Metal Feet Instruction Manual
- August 17, 2024
- Eastbrook
Table of Contents
Eastbrook Freestanding Bath with Metal Feet
Specifications
- Installation: Requires two people
- Weight Capacity: Not designed for weight on the rim
- Maintenance: Soft cloth for cleaning, avoid harsh chemicals
- Additional Parts: Bath feet and waste supplied separately
Product Usage Instructions
Step 1: Receive Your Bath
Make sure you have the necessary tools including an adjustable wrench. Place the bath on a soft surface to prevent scratches.
Step 2: Installation
- Place the bars, washers, and nuts on the bath without tightening.
- Position the feet onto the bars and secure them with the provided nuts and bolts.
- Adjust the feet to align with the bath and tighten all nuts securely.
FAQ
- Q: Can I sit or stand on the bath rim?
- A: No, the freestanding bath is not designed to bear weight on the rim. Avoid sitting or standing on the bath rim.
- Q: What should I do if I notice water leakage at the faucet?
- A : Check and silicone the tap holes to ensure they are secure. Avoid using the bath until the issue is resolved to prevent further damage.
Eastbrook-Freestanding-Bath-with-Metal-Feet -featured Eastbrook-Freestanding- Bath-with-Metal-Feet -featured
The product must be installed in compliance with relevant Water Bylaws
Receive Your Bath
Unpack and check for damage.
After receiving your bath, please unpack and remove all packaging, checking
for damage, damage reported after painting will not be covered. Repack the
bath if it is not being immediately installed. Metal bars required for feet
installation are attached to the underside of the bath.
Protect your bath.
Before commencing installation, ensure the bath is completely protected, leave
the covering in place until the bathroom is complete. Scratches and damage
incurred during installation are not covered by the warranty.
Important information
- Two people are required for installation.
- Please read these instructions thoroughly and retain for future reference
- Always check for pipes and cables before drilling
- A freestanding bath is not designed to take weight on the rim, Do not sit or stand on the bath rim.
- Bath feet and waste are supplied separately.
Parts List
TOOLS REQUIRED
Installation
Step 1
- Ensure the bath is on a soft surface to protect against scratches.
- Place the bars onto the bath, along with the washers and nuts as shown below, do not tighten at this stage to allow for adjustment, taking care not to damage the bath surface
Step 2
- Position the feet onto the bars and secure using the nuts and bolts provided.
- Adjust the position of the feet to align with the bath.
- Tighten all of the nuts so that the feet are secured to the bar and the bars are secured to the bath
Troubleshooting
- Movement in the feet after assembly Please check the feet are assembled properly, and make sure fastener washers and washers are placed correctly.
Maintenance & Cleaning
- Marks on the surface of the bath should be cleaned using a soft damp cloth, for more stubborn marks, toothpaste can be applied and then rinsed thoroughly.
- No harsh cleaning chemicals or abrasive materials can be used on any surface.
- If using coloured oils/creams, carry out a test on a small area prior to use to ensure that these will not cause staining.
- Never pour colored oils/creams directly into an empty bath, always apply them into the bath water.
Warning
Pay attention to the below points if the bath is designed with tap deck.
- The tap holes are not pre-drilled on the deck, drill holes according to your needs.
- Check and silicone the tap holes to make sure they are solid after drilling.
- Check and make sure that there is no water leakage at the faucet
CONTACT
- Technical Helpline: 01452 317890
- Email: technical@eastbrookco.com
- Eastbrook Road, Gloucester GL4 3DB
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>