VOLLRATH 5960810 Door Hinge Template Instruction Manual
- August 11, 2024
- VOLLRATH
Table of Contents
VOLLRATH 5960810 Door Hinge Template
Specifications
- Manufacturer: Vollrath
- Compatibility: Vollrath drop-in induction cookers and warmers
- Material: High-quality surface
- Clamps required: Minimum of 4 for two hob templates, a minimum of 8 for four hob templates
- Installation: Must be done by qualified service or installation personnel
VOLLRATH 5960810 Door Hinge Template
The Vollrath induction templates are specially manufactured to the highest standards. To maximize the life and beauty of these surfaces, read and follow all the instructions.
- The Vollrath induction template must only be installed by a qualified service or installation personnel.
- These induction templates should only be used with Vollath drop-in induction cookers and warmers. The top of the induction unit must be in contact with the bottom of the induction template for proper operation.
- Measure the induction template, induction unit, and countertop before installation to verify the template will fit.
- Apply food-grade silicone between the induction template and the countertop around the entire edge. This will help the template stay in place and reduce liquid from entering the induction unit.
- A minimum of four clamps must be used with two hob templates and a minimum of eight clamps evenly be used with four hob induction templates. All clamps must be evenly spaced.
- All clearance and air circulation requirements for the induction unit(s) must be maintained. See the unit’s operator’s manual specifications.
- Drawer, door, and other clearances need to be considered before installation of the Vollrath temple and the Vollrath induction unit.
- Due to the variety of installation applications and installation methods
- Vollrath is not responsible for damage to the induction template or induction unit during installation or subsequent use.
INSTALLATION OF VOLLRATH INDUCTION TEMPLATES
The strategy or method you choose may differ from the one listed below. Figure 1 shows the method currently used to install an induction template to a Vollrath Buffet Table. Figure 2 shows another method which can be used. (Note: All clips, clamps, and fastening hardware shown are customer-provided.)
Vollrath induction template.
B Countertop or tabletop.
Vollrath drop-in induction unit. Clamp. Figure 1 shows a wood clamp. Figure 2
shows a metal clamp commonly used for mounting under cabinet sinks.
Fastener. F Nut. G Washer.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>