klydoclock CR12DKL Bluetooth Remote Control User Manual
- June 22, 2024
- klydoclock
Table of Contents
klydoclock CR12DKL Bluetooth Remote Control
USER MANUAL
1. Get to know your bluetooth Remote Control
- Device Name: Klydoremote
- PID：0110 VID：0x0508
- Device：Remote Control
2. Key value
Remark：Turn off device by long pressing key and key for 5s, the red led light flashes 3 times（250ms on and 250ms off）. Turn on the device by pressing any key.
3. Pairing
| Steps: | Operation: |
|---|---|
| Pairing broadcasting | Press and hold the key “ ” and “ ” at the same time, |
the blue led light flashes once, and then flashes slowly after 3 seconds, the
device enter
broadcasting mode, then release the keys.
Pairing| The main device searches the corresponding device name, and click
pairing, the Blue led light on the remote control will flash
quickly (150ms on, 150ms off) when pairing.
Pairing result| 1：Pairing succeffully, the blue light keeps on for 3 seconds
and off. 2：Pairing unsuccessfully for over 60 seconds, give up broadcasting
for
pairing.
4. Battery management
- Powered by 500 MAH Lion battery.
- low Battery detection
1） When Vbat<=3.6V+-0.1V（10%）, the device enter low battery status, when press any keys, the red led light flashes.
2）When Vbat<=3.2V+-0.1(0%)，The device enter seriously Low battery status,only when Voltage resumes to 4V, the device resume normal automatically.
Warning:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However. there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television
reception which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
–Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver
–Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
–Consult the dealer or an experienced radio/TV technician for help
NOTE: This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Specifications
-
Device Name: Klydoremote PID0110 VID0x0508 DeviceRemote Control
-
Battery: 500 MAH Lion battery
-
-
Frequently Asked Questions (FAQ)
Q: How do I know when the battery is low?
A: The device will indicate low battery through a notification or LED indicator.
Q: How can I pair the remote control with another device?
A: Follow the pairing steps mentioned in the user manual, including pairing broadcasting, pairing, and checking the pairing result.