Cleveland 24-CDP-10 SteamCraft Generator Style High Speed Convection Steamer Owner’s Manual
- August 9, 2024
- Cleveland
Table of Contents
Cleveland 24-CDP-10 Steam Craft Generator Style High Speed Convection Steamer
Short Form Specifications
Shall be CLEVELAND, Steam Craft® Ultra 10, two compartments, Direct Steam Floor Model Steamer, Model 24-CDP-10, single, large capacity Pressureless Convection Steamer. Choice of Compartment Controls, Manual Bypass Operation Mode, Compensating Thermostat, Exclusive Cold Water Condenser design, Type 430 Stainless Steel exterior and cooking compartments.
Standard Features
- Cooking Capacity for up to ten 12˝ x 20˝ x 21⁄2˝ deep Cafeteria Pans.
- Easy timer with 99 minute Digital Readout in minutes and seconds. Selector Dial with LED Light Descale Indicator. Sure Cook load compensating timer. Manual Constant Steam Mode.
- Separate Switch for Power “on/off.”
- Exclusive Steam Cooking Distribution System: Exclusive Brass Steam Jets produce a high velocity convection steam without fans. Coved Corner design in cooking compartment distributes heat evenly, and is easy to keep clean. Creased top & bottom enhance drainage. Cold Water Condenser for each compartment maintains a dry steam. Fully insulated cooking compartment for thermal efficiency. Removable Stainless Steel Slide Racks.
- Exclusive “Cool to the Touch” Compartment Door Design: Free floating inner door with reversible door gasket provides an airtight seal. Stainless Steel Slam/Latch Door Latch mechanism for reliability.
- Condensate Drip Trough: Provided under lower compartment door to collect condensate.
- Left Hand Door Hinging: Compartment Doors hinged left, control on the right.
- Moisture Separator for incoming steam.
- Pressure reducing Valve or 20-50 psi steam supply pressure, based on a 3⁄4˝ line size.
- Single Cold water Connection.
- NSF Certified 6˝ Stainless Steel Legs with adjustable flanged feet for a one inch level adjustment.
- Standard voltage for controls: 115 volts, 60 Hz. single phase.
- Clean non-toxic, uncontaminated steam is required for all “Direct Steam” steamers.
- Compartment Door Steam Shut Off Switch (SCS)
- Easy timer with 99 minute Digital Readout in minutes and seconds. Selector Dial with LED Light Descale Indicator. Sure Cook load compensating timer. Manual Constant Steam Mode.
- Field Reversible Door Hinging.
Options & Accessories
- Second Pressure Reducing Valve for 50-120 psi steam pressure. (PRV)
- Cafeteria Pans in depths of 1˝, 21⁄2˝, 4˝ and 6˝
- Correctional Packages
Dimension
COMPARTMENT HAS CAPACITY FOR:
- Five, 12˝ x 20˝ x 21⁄2˝ deep Cafeteria Pans
WATER QUALITY REQUIREMENTS (Boilers, Generators)
TTDS| 50-250 ppm
Hardness:| 50 – 200 mm (3-12 gpg)
pH value:| 7.0 – 8.5
CL (Chloride):| max 50 ppm
Cl2 (free chlorine):| max 0.1 ppm
SiO2 (silica):| max 13 ppm
NH2Cl: (mono-chloramine)| max 0.1 ppm
Total Alkalinity:| 50 – 100 ppm
TOTAL CAPACITY (2 Compartments)| UTILITY CONNECTIONS
---|---
10 — 12˝ x 20˝ x 21 ⁄2˝ Cafeteria Pans or| Electrical Supply| Drain: 1.50˝
Dia.
20 — 12˝ x 20˝ x 1˝ Cafeteria Pans or| Water Supply for Condenser 3 ⁄8˝ Dia.
NPT
26 — 12˝ x 20˝ x 4˝ Cafeteria Pans| Steam Supply: 0.75˝ Dia.
DIRECT STEAM| ELECTRIC| COLD WATER| DRAINAGE
---|---|---|---
Steam supply:
Furnish 3 ⁄4˝ IPS minimum line. 20 to 50 psi minimum required. For pressures between 50 to 120 psi, on additional Pressure Reducing Valve must be specified.
| 115V – 1 Phase Controls – 51 Watts| 35 psi minimum 60 psi maximum 3 ⁄4˝
****Dia. NPT for Condenser| 11 ⁄2˝ Dia. Do not connect other units to this
drain. Drain must not be located beneath the steamer itself. No PVC pipe for
drain.
CLEARANCE
Right – 3”, Left – 3”, Rear – 3” (12” on control side if adjoining wall or equipment is over 30” high for service access) Contact factory for variances to clearances
NOTES:
Cleveland Range reserves right of design improvement or modification, as warranted. Many regional, state and local codes exist and it is the responsibility of the owner and installer to comply with the codes. Cleveland Range equipment is built to comply with applicable standards for manufacturers. Included among those approval agencies are U.L/NSF#4 and CSA (AGA, CGA).
CUSTOMER SUPORT
760 Beta Drive, Unit D
Mayfield Village, Ohio 44143
Tel 1.216.481.4900
Fax 1.216.481.3782
Email steam@clevelandrange.com
www.clevelandrange.com
Section 3, Page 22
11 / 23
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>