TARAMPS SFD 4300 Phenolic Driver Free Shipping Worldwide Instruction Manual
- June 13, 2024
- TARAMPS
Table of Contents
TARAMPS SFD 4300 Phenolic Driver Free Shipping Worldwide
Overview
SFD-4300, a Compression Driver, with phenolic resin membrane, carefully designed to be a great ally in the intelligibility of your sound system, providing clean and very well defined timbres from the mid to the mid-high . Strategically built combining design and resistance in its outer casing, with amazing results in any of its applications. handling high power and displacement, within its mechanical specification. Efficiency, Design, Robustness and Performance are synonymous with this product.
ELECTRIC PARAMETERS
- RMS POWER 150 W
- MUSICAL PROGRAM POWER 300 W
- NOMINAL IMPEDANCE 8 Ohms
*AVERAGE SENSITIVITY(@ 1W, 1 m) 112 dB SPL - FLOW DENSITY IN THE GAP 19.200 GAUSS
- FREQUENCY RESPONSE (-10dB) 300Hz to 6.000H2
- RECOMMENDED MINIMUN CUT FREQUENCY (24 dB/8″ active) 500Hz
Sensitivity and response obtained with long oval horn with 30×60 degrees
dispersion.
NOTE: To use the recommended minimum frequency, apply a maximum of 100W
RMS
To obtain the specified power of 150 W RMS, cuts from 800 Hz to 5,500 Hz were
used 24 dB BW Active, in pink noise for two hours without a horn.
MECHANICAL PARAMETERS
- COIL WIRE MATERIAL ROUND COPPER
- COIL SHAPE • Kapton ®
- FERRITE MATERIAL BARIUM
- THROAT DIAMETER 50mm
- DIAPHRAGM MATERIAL PHENOLIC
- COIL DIAMETER 100mm
- WEIGHT 7,700 Kg
- Kapton ® Registered trademark by DUPONT
PRODUCT DIMENSIONS
FREQUENCY RESPONSE VS SPL
IMPEDANCE VS FREQUENCY
WARRANTY TERM
When all our products are produced, they undergo rigorous evaluations, in each
construction process until they are packaged, however, if any type of
abnormality is detected, when opening the package, it must be sent to one of
our authorized service stations , or directly to the factory, if there is not
an authorized technitian in your region. Each and every product must undergo a
technical evaluation so that the defect is identified and proven.
The product has a warranty of 15 (fifteen) months after the issuance of the
invoice, with the legal warranty of 90 days, provided for in article 26, item
II, of law No. 8078/90 ( Brazilian consumer protection code).
Warranty Conditions:
The product must be installed correctly, by a specialized professional, as
well as respecting the product characteristics.
The customer will NOT have the warranty when:
- Exceed the period of 15 (fifteen) months.
- Damages incurred are caused by; transport or handling accident, or humidity.
- Defects caused by improper installation.
- Malfunctions in product parts (torn cone/dust cap, bent or broken speaker housing).
- Coils burned out by excessive power or extreme distortion conditions, causing heating above 240°.
Warranty Coverage:
- Taramps guarantees its products against any defect in material or manufacturing process, provided that, at the discretion of its authorized technicians, it is found to be defective under normal conditions of use.
- The PRODUCT must contain the original label, on which its serial number is inserted.
- To use the warranty, the customer must present the invoice and the warranty term, both of which must contain the serial number on the product label.
Transport
Only products that fall under the terms of warranty coverage will have their
transportation expenses covered, otherwise, the expense will be at the
customer’s expense.
WARRANTY CERTIFICATE
- NAME: ____ _
ADDRESS:
- CITY: ____
- ZIP: __ _
- STATE: FHONE: ___ _
- DEALER: ___ _
- ADDRESS: __ _
- CITY: ____
- ZIP: __ _
- STATE: PHONE: ___ _
- INVOICE NUMBER