midmark 002-11025-00 Latch Kit Installation Guide
- May 15, 2024
- Midmark
Table of Contents
midmark 002-11025-00 Latch Kit
Product Information
Specifications:
- Model Compatibility: All models
- Special Tools Required: None
- Part Numbers: TP200 20-42-FO-00012 Rev A2 ECO088522,
003-10665-00 Rev. AA1 (1/11/2024) Style A
Product Usage Instructions
Installation of Latch [Kit 002-11025-00]
- Turn power switch to off.
- Move toggle switch for water bottles to the middle position to release pressure from water bottles.
- Remove both water bottles from the dental delivery system.
- Remove the mat from the lid and open the top lid by pulling the lever back and lifting the lid all the way up.
- Remove screws (2) from the side cover by hinges and loosen front screws (4) by the control panel.
- Remove screws (2), pry side covers out, and remove the upper rear cover.
- Remove screws (4) and latch from the delivery system.
- Install the new latch with new screws (4).
- Install the upper rear cover by pulling back the side cover and ensuring tabs are under the side cover. Secure with screws (2).
- Install screws (2) from the side cover by hinges and tighten front screws (4) by the control panel.
- Close the lid and push down on the middle until a click is heard.
- Install the mat onto the lid.
- Install both water bottles onto the delivery system.
- Move the toggle switch to add pressure to the water bottle for use.
- Turn power switch to on.
FAQ
- Q: Do I need any special tools for installing the latch?
- A: No, special tools are not required for latch installation.
- Q: How do I release pressure from water bottles before starting the installation process?
- A: Move the toggle switch for water bottles to the middle position to release pressure.
- Q: What should I do if I hear a click during latch installation?
- A: Hearing a click indicates that the latch has been properly installed. Continue with the remaining steps as instructed.
Product Overview
Installation Instruction
- Step 1:
- Turn the power switch to off.
- Step 2:
- Move the toggle switch for water bottles to the middle position to release pressure from water bottles.
- Step 3:
- Remove both water bottles from the dental delivery system.
- Step 4:
- Remove the mat from lid. Open top lid by pulling lever back and lifting lid all the way up.
- Step 5:
- Remove screws (2) from side cover by hinges. Loosen front screws (4) by control panel.
- Step 6:
- Remove screws (2). Pry the side covers out and remove the upper rear cover.
- Step 7:
- Remove screws (4) and latch from the delivery system.
- Step 8:
- Install a new latch with new screws (4).
- Step 9:
- Install the upper rear cover by pulling the back side cover and ensuring tabs are under side cover as shown. Secure with screws (2)
- Step 10:
- Install screws (2) from side cover by hinges. Tighten the front screws (4) by the control panel.
- Step 11:
- Close lid and push down on the middle until a click is heard
- Step 12:
- Install mat onto lid.
- Step 13:
- Install both water bottles onto delivery system
- Step 14:
- Move the toggle switch to add pressure to the water bottle for use.
- Step 15:
- Turn the power switch to on
2024 Midmark Corp.
- 60 Vista Drive Versailles, OH 45380 USA
- 1.800.643.6275 |
- 1.937.526.3662
- midmark.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>