BURNDY BIPC3501-0SC Insulation Piercing Connector Owner’s Manual
- July 8, 2024
- BURNDY
Table of Contents
BURNDY BIPC3501-0SC Insulation Piercing Connector
Product Specifications
- Model: BIPC3501/0SC
- Type: Insulation Piercing Connector
- Material: Copper and Aluminum
- Run Capacity: 1/0-350
- Tap Capacity: 1/0-350
- Installation Technology: Shearing
- Socket Type: 6-point impact driver
- Installation Method: No torque wrench required
Product Usage Instructions
- Connector for Cu/Al, Run: 1/0-350,
- Tap: 1/0-350
- By Burndy
- Catalog # BIPC3501/0SC
Insulation Piercing Connector for Copper and Aluminum, Run:1/0-350, Tap: 1/0-350, ideal for splicing, tapping and dead-ending aluminum and copper conductor with shearing installation technology. 6-point socket impact driver for easy installation and removal, no torque wrench required.
Features
- Flexibility! One connector allows for tap, splice or dead-end configurations
- Time Savings! Requires no cable stripping, conductor brushing, inhibitor application or after installation taping
- Engineered shear bolt technology applies consistent torque for efficient and reliable connectors
- Easy installation and removal – only requires 6-point socket impact driver
- cULus Listed Splicing Wire Connector, AL9CU Rated, for copper and aluminum conductor combinations up to 90 degrees C, *600 Volt applications
- Insulation piercing design for use in multiple applications – overhead covered and bare taps, service and metering connections, and lighting system work
Safety Precautions
Before using the Insulation Piercing Connector, ensure the power source is
turned off and all safety measures are in place.
Installation Process
- Identify the run and tap conductors to be connected.
- Position the connector over the conductors to be spliced, tapped, or dead-ended.
- Use the 6-point socket impact driver to install the connector securely.
- No torque wrench is required for installation due to the shearing technology.
Removal Process
To remove the connector, use the 6-point socket impact driver in the reverse
direction to loosen and detach it from the conductors.
General
- Application – For Use On
- Copper and Aluminum
- Catalog Number
- BIPC3501/0SC
- UPC
- 621945653528
Logistics
- Carton Quantity 4
- Pallet Quantity 360
Product Assets
- Catalogs – Full Line BURNDY Catalog
- Catalogs – Section A – Mechanical
- Installation Manuals – Overhead Secondary Networks
- Insulation Piercing Connector BIPC
A proud member of the Hubbell Family.
©2024 Hubbell Incorporated. All rights reserved.
BRDY-BIPC35010SC-SPEC-EN | REV 6/2024
Frequently Asked Questions
Q: What is the recommended application for this Insulation Piercing
Connector?
A: The connector is ideal for splicing, tapping, and dead-ending aluminum and
copper conductors.
Q: Is a torque wrench necessary for installation?
A: No, the installation process does not require a torque wrench as the
technology used eliminates this need.
Q: How many units are packed in a carton and pallet?
A: Each carton contains 4 units, while a pallet holds 360 units of the
Insulation Piercing Connector.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>