TECNO CL9 CAMON 30 Premier 5G Smart Phone User Manual
- August 9, 2024
- TECNO
Table of Contents
TECNO CL9 CAMON 30 Premier 5G Smart Phone
Exploded diagram specification
| 1 | OLED | 2 | FC HEAT FILM |
|---|---|---|---|
| 3 | VC | 4 | MID COVER ASM RNM |
| 5 | MAIN PCBA | 6 | UP SPK |
| 7 | OIS 50M CAMERA | 8 | F CAMERA |
| 9 | UW 50M CAMERA | 10 | 50M 3X FOLD CAMERA |
| 11 | RFPA FOIL | 12 | BB FOIL |
| 13 | 50M OIS COPPER | 14 | MAIN FPC CON COPPER |
| 15 | WCN FOIL | 16 | CAM CON FB |
| 17 | 50M UW COPPER | 18 | CAM COP FOIL |
| 19 | 50M UW CAM CON FB | 20 | CAMERA BRACKET PET |
| 21 | CAMERA BRACKET | 22 | MACHINE SCREW |
| 23 | F CAM HOT FLIM | 24 | HEAT DISSIPATION RUBBER |
| 25 | DECO CON FOAM | 26 | LCD CON FOAM |
| 27 | REAR FLASH CON FB | 28 | R CAM SEAL FOAM |
| 29 | HW PRO MYLAR | 30 | MC SCREW |
| 31 | REAR FLASH FPC | 32 | BATTERY COVER |
| 33 | CNC CAM DECO 2 | 34 | CNC CAM DECO 1 |
| 35 | BATTERY | 36 | MAIN FPC |
| 37 | CABLE 1 | 38 | CABLE 2 |
| 39 | MOTOR | 40 | NFC |
| 41 | BOX SPEAKER | 42 | SUB-PCBA |
| 43 | ANT SUB PCBA | 44 | SIM TRAY |
| 45 | LCD SEAL RUBBER | 46 | USB RUBBER |
| 47 | CABLE CON FB | 48 | FM |
| --- | --- | --- | --- |
| 49 | DOWN SPEAKER | 50 | R FLASH DECO ASM |
| 51 | LOW HOUSING ASM | 52 | LENS |
Know your phone
- Front camera
- Volume + button
- Volume – button
- Power button
- NFC
SIM card installation
- Power off your phone.
- Refer to the following picture for SIM card installation.
Charging the phone
You can charge your phone with a charger or by connecting it to a computer
using a USB cable (comes with the phone). Use only TECNO chargers and cables.
Other chargers or cables may damage the phone and invalidate its warranty
.
FCC
Labeling requirements.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference. (2) This device must accept any interference received, including
interference that may cause undesired operation.
Information to the user.
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
device.
Information to the user
Note : This device has been tested and found to comply with the limits
for a Class B digital device, under part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This device generates, uses and may radiate radio
frequency energy and, if not installed and used by the instructions, may cause
harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. Suppose this
device does cause harmful interference to radio or television reception (able
to be determined by turning the device off and on). In that case, the user is
encouraged to try to correct the interference by one or more of the following
measures: -Reorient or relocate the receiving antenna. -Increase the
separation between the device and receiver. -Connect the device to an outlet
on a circuit different from that to which the receiver is connected. -Consult
the dealer or an experienced radio/TV technician for help.
Specific Absorption Rate (SAR) information:
This mobile phone meets the government’s requirements for exposure to radio
waves. The guidelines are based on standards developed by independent
scientific organizations through periodic and thorough evaluation of
scientific studies. The standards include a substantial safety margin designed
to assure the safety of all persons regardless of age or health. FCC RF
Exposure Information and Statement. The SAR limit of USA (FCC) is 1.6 W/kg
averaged over one gram of tissue. Device types: CL9(FCC ID: 2ADYY-CL9) has
also been tested against this SAR limit. The highest SAR value reported under
this standard during product certification for use at the ear is 0.65W/kg and
when properly worn on the body is 0.79W/kg.
Body-worn Operation
This device was tested for typical body-worn operations. To comply with RF
exposure requirements, a minimum separation distance of 1.0 cm must be
maintained the user’s body and the handset, including the antenna. Third-party
belt clips, holsters, and similar accessories used by this device should not
contain any metallic components. Body-worn accessories that do not meet these
requirements may not comply with RF exposure requirements and should be
avoided. Use only the supplied or approved antenna.
HiOS runs on AndroidTM OS. Android is a trademark of Google LLC.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>