Eastbrook 36.0061 Vanity Units Bathroom Furniture Instruction Manual

Table of Contents

Specifications:

Installation for Floorstanding Vanity Units:

Mark two holes levelly on the wall.
Drill the holes using the appropriate size drill bit.
Insert expansion wall plug or suitable alternative wall fixing.
Screw in the tapping screws and add cover caps.
Apply an adequate amount of silicone between the basin and unit to prevent water ingress.

Installation for Wall Hung Vanity Units:

Components Adjustment:

Drawer Slider Adjustment: Turn the screw clockwise to raise the drawer and anti-clockwise to lower it.
Soft Closing Hinge Adjustment: Adjust up/down, in/out, left/right as needed for proper operation.
Wall Hanging Bracket Adjustment: Lengthen the hook’s protrusion by turning the screw anti-clockwise.

Aftercare and Maintenance:

Q: What should I do if I notice any damage to the vanity unit during installation?

A: Never install damaged products or components. Contact customer support for assistance and replacement parts if needed.

Q: How often should I check the hinges and sliders for adjustment?

A: It is recommended to check and adjust hinges and sliders every 6 months to ensure smooth operation of the vanity unit.

Q: Can I use any type of cleaning agent on the vanity unit?

A: Avoid abrasive or acidic cleaning materials. Use cleaning agents with a neutral pH of 7 to maintain the surface finish.

PLEASE READ THE BELOW NOTES BEFORE INSTALLING YOUR VANITY UNITS.

Use protective gloves and eye protection at all times
Please use qualified plumbers to install the vanity unit
2 people are required to install the units
Check the parts are fully supplied
Never install products or components that look damaged
Hinges for doors and sliders for drawers may need to be checked and adjusted to achieve proper position after installation
Please avoid direct sunlight as this will affect the painted surface color change
If fixing to a stud or paneled wall, the proper framework is required to support a wall-hung unit

NECESSARY TOOLS (not supplied)

Installation for Floorstanding Vanity Units
- Mark the two holes levelly on the wall.
- Drill the holes using the drill bit of the proper size.
- Insert expansion wall plug or appropriate alternative wall fixing.
- Screw in the tapping screws.
- Add cover caps on the screws.
- When fitting the basin to the unit, adequate silicone is required between the basin and unit to prevent potential water ingress.
Installation for Wall Hung Vanity Units
- Mark the holes levelly on the wall.
- Drill the holes using the drill bit of the proper size. Insert expansion wall plug or appropriate alternative wall fixing.
- Screw in the tapping screws.
- When fitting the basin to the unit, adequate silicone is required between the basin and unit to prevent potential water ingress.

Drawer slider adjustment
If you need some fine adjustment, turn the screw clockwise to get the drawer “up”, and turn the screw anti-clockwise to get the drawer “down”
Soft closing hinge adjustment
Wall hanging bracket adjustment
- Turn the screw anti-clockwise to lengthen the hook’s protrusion
- Once the vanity unit is fitted, if required, turn this screw clockwise for “down” and anti-clockwise for “up”

Make sure your bathroom is well-ventilated
Do not use abrasive cleaning materials which will hurt the surface finish
Do not use any cleaning with acidic substances or soda. We suggest using cleaning agents with a PH of 7
The vanity unit must be kept dry and not subject to continuous moisture
All spillages and splashes must be wiped off
Do not lean on fully opened doors or drawers
Check the hinges and sliders every 6 months and any loose screws must be tightened