HEINNER HIM-120BK Ice Maker Instruction Manual

: August 5, 2024
: HEINNER

Table of Contents

HEINNER HIM-120BK Ice Maker
INTRODUCTION
SAFETY PRECAUTIONS
PRODUCT DESCRIPTION
CONTROL PANEL OPERATION
TROUBLESHOOTING
Documents / Resources

HEINNER HIM-120BK Ice Maker

Thank you for purchasing this product!

INTRODUCTION

Before using the appliance, please read carefully this instruction manual and keep it for future reference.
This instruction manual is designed to provide you with all required instructions related to the installation, use and maintenance of the appliance. In order to operate the unit correctly and safety, please read this instruction manual carefully before installation and usage.

SAFETY PRECAUTIONS

When using an electrical appliance, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and/or injury, including the following:

Read all instructions before using.
Remove all packing material and carefully check your ice maker to ensure it is in good condition and that there is no damage to the ice maker or power cord and plug.
Before using the Ice maker for the first time, please wait 2 hours after positioning it, and keep the transparent lid open for at least 2hours
Pure water is not allowed to be used on this unit, spring water is recommended.
Ensure the voltage is compliant with the voltage range stated on the rating label, and ensure the earthing of the socket is in good condition.
If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
Do not upend this product or incline it over a 45 angle.
To protect against risk of electric shock, do not pour water on cord, plug and ventilation, immerse the appliance in water or any other liquid.
Unplug the appliance after using or before cleaning.
Keep the appliance 8cm from other objects to ensure the good heat releasing.
Do not use the accessories which are not recommended by Manufacturer.
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. Children should be supervised to ensure that they do not play with the appliance.
Do not use the appliance close by flames, hot plates or stoves.
Do not switch on the power button frequently (ensure 5min. interval at least) to avoid the damage of compressor.
Metal sheet or other electric objects are not allowed to be inserted into the appliance to avoid fire and short circuit.
Do not use outdoors.
Never clean with scouring powders or hard implements.
Please keep the instruction manual.
Warning : Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.
This appliance is intended to be used in household only.
The refrigerant and insulation blowing gas is flammable, when disposing of the appliance, do so only at an authorized waste disposal centre. Do not expose to flame.

WARNING : When positioning the appliance, ensure the supply cord is not trapped or damaged.
WARNING : Do not locate multiple portable socket outlets or portable power supplies at the rear of the appliance.

To avoid contamination of food, please respect the following instructions:

Opening the door for long periods can cause a significant increase of the temperature in the compartments of the appliance.
Clean regularly surfaces that can come in contact with food and accessible drainage systems.
Clean water tanks if they have not been used for 48 h; flush the water system connected to a water supply if water has not been drawn for 5 days.
If the refrigerating appliance is left empty for long periods, switch off, defrost, clean, dry, and leave the door open to prevent mould developing within the appliance.)

PRODUCT DESCRIPTION

Transparent Lid
Water box
Ice shove board
Ice collecting basket
Front housing
Ice shovel
Buttons
Upper cover
Bullet evaporator
Housing

CONTROL PANEL OPERATION

ON/OFF: ON OFF switch button
Clean : Cleaning function button
ICE FULL: Ice full alarm indicator light
ADD WATER: Water shortage alarm indicator light
ICE MAKING: Ice making indicator light.

Plug in the power, the “ICE MAKING ” indicator light flashes, and the machine will start the deicing function. Press the ON/OFF button to start the machine, the ICE MAKING ” indicator light is always on and then the ice block will be made automatically. After the ice making is completed, the deicing will be carried out, and then the ice shoveling function will be entered, and so on.

ADD WATER
When the indicator of this button turns to red, it means insufficient water to water reservoir, you need to add enough water and press POWER button to restart the machine.

ICE FULL
When the ice reach to the max storage capacity, the indicator of this button will flash, and the machine will stop working. What you need to do is pouring out the ice, if the position of ice is lower than the position of ice bin full sensor, the machine will restart automatically.

ICE
MAKING When this light is always on, it means that the ice maker is making ice.

CLEAN : Cleaning function Plug in the power, the ” ICE MAKING ” indicator light flashes . After pressing the Clean button, the product cleaning function starts. Do not disconnect the power supply during the cleaning. After the cleaning, the product automatically enters the standby mode.

USING INSTRUCTIONS & CLEANING GUIDANCE

Note : Water reservoir and pipeline should be well cleaned before use.

Step 1: Open the lid and take out the ice basket to add appropriate water into water reservoir.
Note : The water poured into water reservoir should be lower than the water reservoir’s MAX position. When water volume goes beyond the max, please open the
bottom water drain plug to drain the spare water out. Then close the transparent lid.
Step 2 : Plug in the power and press the ON/OFF button to start the machine
Note : For the first three cycles, the ice may be small and irregular in size.
Note : When the ice collecting tray is full please remove the ice immediately, Do not allow the ice collecting tray to overfill.

CLEANING

Clean the inner liner, ice collecting basket, water box, ice shovel and evaporator frequently. When cleaning, unplug the unit and remove the ice cubes. Use a diluted solution of water and vinegar to clean the inside and the outside surface of the Ice maker. Do not spray Ice maker with chemicals or diluted agents such as acids, gasoline or oil. Rinse thoroughly before starting.
Keep ventilation openings in the appliance enclosure, or in the built in structure, clear of obstruction. Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer.
Reuse the machine after being idled for a period of time, it may not have enough water to pump for air retard, and the indicator of “ADD WATER” will keep lighting. At this time, you just need to press POWER button again, the machine can enter normal state.
To ensure the cleanness of ice, please change water for water reservoir at least once one day. If do not use for a long time, please drain the water out and clean it up.
If the compressor takes a strike action for shortage water, fully water or interruption of power supply, it will delay for 3 mins to start up after restarted.
Always use fresh water before starting ice production either at initial installation or after a long shutoff period.

TROUBLESHOOTING

Please note, if a power failure occurs due to disconnection of the power cord, or the power button has been pushed off during an ice making cycle, small ice chips may formed and lodge in the automatic shovel causing it to jam. If this occurs, the ice chips may be removed by disconnecting the power cord and gently pushing the shovel to the rear of the cabinet and removing the ice chips, then restarting.
Please check if the water reservoir is flat when the ice shovel can not remove the ice to ice basket. If not, please push the i ce shovel gently by finger, then press POWER button to restart.

PROBLEM	POSSIBLE CAUSE	SUGGESTED SOLUTIONS

The compressor works abnormally

with a buzzing noise

| The voltage is lower than recommended| Stop the ice maker and do not restart until the voltage is normal.
Water shortage indicator light is on| 1. There is no water
2. The pump is full of air| 1. Add to some water until it reaches MAX position

2. Press POWER button to restart

the machine

Indicator lights on display are not on| Blown fuse/ No power| Replace fuse / Turn power on
The ice made is too large and with pieces sticking together| Ice of previous cycles left in the water tray| Take out the ice under the standby state
The ice making process was correct, but no ice came out.| 1. The compressor has no refrigerant

2. Compressor damaged

3. Fan motor damaged

| Call the service
All indicators twinkle simultaneously| 1. The water box is blocked by ice.

2. The motor is stuck, or the motor falls off, or the motor is damaged

3. Micro switch damaged

| 1. Unplug the power to take out the ice which under the ice shovel, then plug in power again, and press the POWER button. After 3 minutes, the machine will restart automatically.

2. Call the service

The machine has been working, but

the water has been warming

| Solenoid broke down| Replace the solenoid valve
When the ice is full, the machine does not display the ICE FULL Icon|

Ice full sensor damaged
Sunlight interference

| 1. Replace the ice full sensor

2. Making ice indoor

3. Call the service

If the power cord is damaged; it must be replaced by the manufacturer, its service agent or a similarly qualified person in order to avoid a hazard. Fill with potable water only.
It is normal for the compressor and condenser surface to reach temperatures between 70°C and 90°C during operation and surrounding areas may be very hot. Due to fast freezing, ice cubes may appear “Cloudy”. This is air trapped in the water and will not affect quality or taste of ice. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.

Do not immerse in water

Warning
keep ventilation openings, in the appliance enclosure or in the built in structure clear of obstruction.
Warning
do not use mechanical devices or other means to accel er ate to defrosting process, other than those recommended by the manufacturer.
Warning
do not damage the refrigerant circuit.
Warning
do not use electrical appliance inside the food storage compartments of the appliance, unless they are of the type recommended by the manufacture.

TECHNICAL FICHE

Power 12 0 W
Voltage 220 240V, 50 Hz
Capacity 12KG/24H

Environment friendly disposal
You can help protect the environment! Please remember to respect the local regulations: hand in the non-working electrical equipment’s to an appropriate waste disposal center.

HEINNER is a registered trademark of Network One Distribution SRL. Other brands and product names are trademarks or registered trademarks of their respective holders. No part of the specifications may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from NETWORK ONE DISTRIBUTION. This product is in conformity with norms and standards of European Community.

Importer: Network One Distribution
Marcel Iancu Street, no 3-5, Bucharest, Romania
Tel : +40 21 211 18 56,
www.heinner.com
www.nod.ro