HEINNER HCM-D915BKS Coffee Maker Instruction Manual

: June 4, 2024
: HEINNER

Table of Contents

HEINNER HCM-D915BKS Coffee Maker
INTRODUCTION
PACKAGE CONTENTS
SAFETY MEASURES
PRODUCT DESCRIPTION
USING THE APPLIANCE
CLEANING AND MAINTENANCE
TECHNICAL FICHE
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

HEINNER HCM-D915BKS Coffee Maker

Thank you for choosing this product!

INTRODUCTION

Please read this instruction manual carefully before using it and kee it for later information
This manual is conceived for offering you all of the necessary info regarding the installation, using and maintenance of the machine. For the correct and safely use of the machine, please, read this manual before installation and use.

PACKAGE CONTENTS

Coffee maker
Instruction Manual
Warranty card

SAFETY MEASURES

When using electrical appliance. Basic safety precautions should always be followed including the following:

Read all instructions.
Make sure that your outlet voltage corresponds to the voltage stated on the rating label of the coffee maker.
To protect against fire, electric shock and injury to persons do not immerse cord, plug, or in water or other liquid.
Close supervision is necessary when any appliance is used by or near children.
Unplug from outlet when not in use and before cleaning. Allow to cool before putting on or taking off parts, and before cleaning the appliance.
Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions or has been damaged in any manner. Return appliance to an authorized service facility for examination, repair or adjustment.
The use of accessory not recommended by the appliance manufacturer may result in fire, electric shock or injury to persons.
Do not use outdoors.
Do not let cord hang over edge of table or counter or touch hot surfaces.
Do not place on or near a hot gas or electric burner, or in a heated oven.
Do not use appliances for other than intended use.
Do not clean the container with cleansers, steel wool pads, or other abrasive material.
To disconnect, turn any control to “Off”, remove plug from wall outlet. Always hold the plug. But never pull the cord.
Scalding may occur if the cover is removed during the brewing cycles. Be careful not to get burned by the steam.
Some parts of appliance are hot when operated, so do not touch with hand. Use handles or knobs only.
Never leave the empty carafe on the warming plate otherwise the carafe is liable to crack.
Do not set a hot container on a hot or cold surface.
Do not let the coffee maker operate without water.
Never use the appliance if the carafe shows any signs of cracks or carafe having a loose or weakened handle. Only use the carafe with this appliance. Use carefully as the carafe is very fragile.
To reduce the risk of fire or electrical shock, do not remove the cover. No user serviceable parts inside. Repair should be done by authorized service personnel only.
WARNING:TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK. DO NOT REMOVE COVER.NO USER SERVICEABLE PARTS INSIDE. REPAIR SHOULD BE DONE BY AUTHORIZED SERVICE PERSONNEL ONLY.DO NOT IMMERSE IN ANY LIQUID. FOR HOUSEHOLD USE ONLY.
This appliance is intended to be used in households only.
Save these instructions.

PRODUCT DESCRIPTION

HEINNER-HCM-D915BKS-Coffee-Maker-FIG1

CONTROL PANEL

USING THE APPLIANCE

Check that all accessories are complete, and the unit is not damaged. Fill water into water tank to the MAX level and brew water for several times without coffee powder, then discard the water. Clean and dry all detachable parts thoroughly according to the section “CLEANING AND MAINTENANCE”.

USING THE APPLIANCE

Open the top lid and fill the water tank with drinking water. The water level should not exceed MAX level as indicated on the water gauge.
Place the funnel into the funnel support, and make sure it is assembled correctly, otherwise, the top lid cannot be closed. Place a permanent filter in the funnel.
Add coffee powder to the permanent filter. Usually, a cup of coffee needs a level spoonful of coffee powder, but you may adjust according to personal taste. Close the top lid completely.
Insert the carafe with the handle closed onto the warming plate horizontally.
Plug the power cord into the outlet.
Press ON/OFF button, its indicator illuminates in red, the appliance begins to work.
The brewing process can be interrupted by pressing the ON/OFF button at any time, and the indicator of ON/OFF button will extinguish, indicating your coffee maker is power off. Note: You can take out the carafe, pour and serve at any time. The appliance will stop dripping automatically. But the time cannot exceed 30 seconds.
Remove out the carafe to serve when finished brewing (about one minute later after the coffee stops dripping out.)
Always turn the coffee maker off and disconnect the power supply when not use.

NOTE: Pay attention to pour the coffee out, otherwise you may be hurt as the temperature of coffee just finished is high.

DELAY FUNCTION
If you do not want the coffee maker to start operation immediately, for example now it is 8:10, you hope that the coffee maker will automatically start working at 13:00, first follow steps 1 to 5 of above section, and then you can set the automatic start function as follows:

Press PROGRAM button one time, set the current time by pressing HOUR and MINUTE button repetitively that is 8:10.
Note: The time cycle is 24 hours.
Press PROGRAM button one time, the indicator of ON/OFF button will illuminates in green and flash. (Means the coffee make enter the presetting time state.)
Set the delayed starting time by pressing HOUR and MINUTE button repetitively that is 13:00.
Press the DELAY BREW button, the indicator of ON/OFF button is illuminated in green. After a while, the LCD will display the current clock. You may see the automatic start time by pressing DELAY BREW.
Note: You may cancel the automatic start function by pressing ON/OFF. If you want to change the automatic start time, only following the above 2-4 steps again.
When the time is due, the indicator of ON/OFF button will illuminate in red and the appliance starts brewing.
When the process is finished, if you do not want to serve immediately, keep the coffee maker is energized, the coffee can be kept warm in the warming plate. And the appliance will shut off automatically after 40 minutes from the ON/OFF button being activated if it has not been manually disconnected at the completion of brewing. For an optimum coffee taste, serve it just after brewing.
Note: During brewing process, the buttons of “PROGRAM”, “DELAY BREW”, and “HOUR” and “MINUTE” are invalid.

CLEANING AND MAINTENANCE

CAUTION: Be sure to unplug this appliance before cleaning. To protect against electrical shock, do not immerse cord, plug or unit in water or liquid. After each use, always make sure plug is first removed from wall outlet.

Clean all detachable parts after each use in hot, sudsy water.
Wipe the product’s exterior surface with a soft, damp cloth to remove stains.
Water droplets may buildup in the area above the funnel and drip onto the product base during brewing. To control the dripping, wipe off the area with a clean, dry cloth after each use of the product.
Use a damp cloth to gently wipe the warming plate. Never use abrasive cleaner to clean it.
Replace all parts and keep for next use.

REMOVING MINERAL DEPOSITS
To keep your coffee maker operating efficiently, you should clean away the mineral deposits left by the water regularly according to the water quality in your area and the frequency of use. If the mineral deposit is excessive, the appliance will represent the following signs:

Fill the tank with water and descaler to the MAX level (the proportion of water and descaler is 4:1, details refer to the instruction of descaler. Please use “household descaler”, you can use the citric acid (obtainable from chemists or drug stores) instead of the descaler (one hundred parts os water and three parts of citric acid).
Place the serving cup under the brew basket.
Make ensure funnel are assembled in place.
Switch on the appliance and allow it to “brew” de-scaling solution.
After “brew” one-cup solution, switch off the appliance.
Leave the solution stay for 15 minutes and repeat step 3-5.
Switch on the appliance and run off the solution until the water tank is completely empty.
Rinse by operating the appliance with water at least 3 times.

HINTS FOR GREAT-TASTING COFFEE

A clean coffee maker is essential for making great-tasting coffee. Regularly clean the coffee maker as specified in the “CLEANING AND MAINTENANCE” section. Always use fresh, cold water in the coffee maker.
Store unused coffee powder in a cool, dry place. After opening a package of coffee powder, reseal it tightly and store it in a refrigerator to maintain its freshness.
For an optimum coffee taste, buy whole coffee beans and finely grind them just before brewing.
Do not reuse coffee powder since this will greatly reduce the coffee’ flavor. Reheating coffee is not recommended as coffee is at its peak flavor immediately after brewing.
Clean the coffee maker when over-extraction causes oiliness. Small oil droplets on the surface of brewed, black coffee are due to the extraction of oil from the coffee powder.
Oiliness may occur more frequently if heavily roasted coffees are used.

TECHNICAL FICHE

Rated voltage 220-240 V
Rated frequency 50-60Hz
Power 900W

Environment-friendly disposal
You can help protect the environment! Please remember to respect the local regulations: hand in the non-working electrical equipment’s to an appropriate waste disposal center.

HEINNER is a registered trademark of Network One Distribution SRL. Other brands and product names are trademarks or registered trademarks of their respective holders. No part of the specifications may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from NETWORK ONE DISTRIBUTION.
Copyright © 2013 Network One Distribution. All rights reserved.
www.heinner.com, http://www.nod.ro
http://www.heinner.com, http://www.nod.ro

This product is in conformity with norms and standards of European Community.

Importer: Network One Distribution
Marcel Iancu Street, no 3-5, Bucharest, Romania
Tel: +40 21 211 18 56, www.heinner.com , www.nod.ro