AlphaRex LUXX-Series LED Projector Headlights Installation Guide
- July 31, 2024
- ALPHAREX
Table of Contents
AlphaRex LUXX-Series LED Projector Headlights
Installation Guide for 15-23 Dodge Charger | SRT Hellcat Headlights
ALPHAREX specializes in designing and producing superior and uniquely stylish aftermarket automotive performance lighting with unrivalled innovative technology. This installation guide takes you through the step-by-step process of installing your new ALPHAREX HEADLIGHTS for your 2015-23 Dodge Charger | SRT Hellcat. DO NOT USE DIELECTRIC GREASE!
PART I REMOVE HEADLIGHTS
INSTALLATION TOOLS
PREPARE THESE TOOLS FOR INSTALLATION
NOTE : Whenever using a power tool, please make sure do not overtighten the bolts.
STEP 1. DISCONNECTING THE NEGATIVE BATTERY TERMINAL
Whenever working on your vehicle, always start by disconnecting the negative
battery terminal.
STEP 2. REMOVE THE FRONT BUMPER
Begin by extracting the push-in pins from the radiator support cover.
Remove the two 10mm bolts, located individually on either side of the upper bumper corner. Extract the four push-in pins from both sides of the wheel fender.
Subsequently, spread open the fender liner widely and use the wrench to disengage the two 10mm bolts securing the front bumper.
Repeat the identical steps on the opposite side of the wheel fender. Open the
fender liner widely and remove the two 10mm bolts securing the front bumper.
Gently detach the front bumper by pulling outward from each side, disengaging
it from the
mounting clips.
Disconnect the fog light connectors and side marker connectors, then proceed to remove the front bumper entirely. Set it aside for later reinstallation
STEP 3. REMOVE THE HEADLIGHT BOLTS
Remove the 4 X 8mm bolts from the headlight assembly. Follow the same steps
for the other side.
STEP 4. REMOVE THE HEADLIGHTS
Gently pull the headlight assembly outward to disengage. Unplug the
headlight’s sockets to complete the headlights removal.
INSTALL HEADLIGHTS
STEP 1. TAP THE FUSE AND ROUTE THE DRL HARNESS
To ensure proper operation of the Daytime Running Lights (DRL), it’s
essential to connect to the fuse and route the harness accordingly. Begin by
locating the fuse box. Then, attach the red wire to the positive (+) terminal
and the black wire to the negative (-) ground terminal on the firewall.
To initiate, open the fuse box and tap the red wire into the fuse F39 (10A).
Next, proceed to route the DRL wire harness towards the headlights.
STEP 2. PLUG THE HEADLIGHTS
Connect the headlight socket, DRL connector, and turn signal connector to the
new ALPHAREX headlight assembly. DO NOT USE DIELECTRIC GREASE!
STEP 3. INSTALL THE HEADLIGHTS
Screw the 4 X 8mm bolts into place securely, ensuring a proper fit. Repeat
the same steps for the other side of the headlights.
To complete the installation, reverse the uninstallation process, ensuring all previous steps are followed in the opposite order.
STEP 4. TEST THE HEADLIGHT FUNCTIONS
Test the functions of your ALPHAREX headlights to ensure everything works properly.
STEP 5. ADJUST HEADLIGHT LEVEL
Once everything has been tested, aim your ALPHAREX headlights by parking 25ft
from a wall and level the headlight evenly.
STEP 6. COMPLETE INSTALLATION
Congratulations! You have completed the installation for ALPHAREX 15-23 Dodge
Charger | SRT Hellcat HEADLIGHTS.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>