DoorBird D2100E IP Video Door Station Instruction Manual
- June 12, 2024
- DoorBird
Table of Contents
Technical Drawings
D2100E
VERSION 1.6, MIN. HW 1.5
ASSEMBLY INSTRUCTIONS AND ILLUSTRATIONS
– The front panel must be exactly 3.00 mm thick.
– The main electrical unit of the IP video door station must be pressed flat
against the front panel. A gasket is attached on the main electrical unit ex
works.
– Underneath the main electrical unit, enough space for the Phoenix and CAT
cabling must be planned for (approx. 5 cm / 1.97 in).
– In order to ensure an easy installation, a free area around each module
should be planned (approx. 5 mm / 0.2 in).
: Important note for cavity mounting (e.g. in pedestals and mailboxes):
To protect the electronic units, please ensure that the technical components are protected against dripping and running water caused by condensate or entering the mounting space through openings. To protect the electronic units, ensure that the mounting space inside is not accumulating water.
Sufficient air circulation must be ensured, as well as unobstructed drainage of water at the base of the installation.
Failure to do so will result in warranty being declined.
D21x CALL BUTTON
ROUND STAINLESS STEEL BUTTON
ROUND BUTTON WITH NAMEPLATE
KEYPAD MODULE WITH 16 KEYS
KEYPAD MODULE WITH 12 KEYS
DISPLAY-/INFO PANEL MODULE
FINGERPRINT READER MODULE
MTM56S
MTM14E
MTM18A
It is possible that these manual still contains typographical errors or printing errors. The information in this manual will be checked regularly and corrections will be made in the next version. We accept no liability for errors of a technical or printing nature and their consequences.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>