HAVIS DS-PAN-1500 Docking Station For Panasonic TOUGHBOOK 40 Laptop Owner’s Manual

HAVIS DS-PAN-1500 Docking Station For Panasonic TOUGHBOOK 40 Laptop

DS-PAN-1500 Series

• DS-PAN-1501
• DS-PAN-1501-4
• DS-PAN-1502
• DS-PAN-1502-4
• DS-PAN-1503
• DS-PAN-1504
• DS-PAN-1504-4
• DS-PAN-1505
• DS-PAN-1505-4

Before Beginning

• Havis is pleased to provide this Owner’s Manual to aid in the proper installation and use of the DS-PAN-1500 Series Docking Station for the Panasonic TOUGH BOOK 40 laptop computers.
• For questions regarding the set-up of your DS-PAN-1500 Series Docking Station, please contact Havis at 1-800-524-9900 or visit www.havis.com for additional product support and information.

This Owner’s Manual applies to the following Part Numbers:

• DS-PAN-1501
• DS-PAN-1501-4
• DS-PAN-1502
• DS-PAN-1502-4
• DS-PAN-1503
• DS-PAN-1504
• DS-PAN-1504-4
• DS-PAN-1505
• DS-PAN-1505-4

WARNING

• NEVER STOW OR MOUNT THE DOCKING STATION DIRECTLY IN A VEHICLE AIRBAG DEPLOYMENT ZONE.
• DO NOT USE COMPUTER WHILE DRIVING.

CAUTION

• READ ALL INSTRUCTIONS THOROUGHLY BEFORE BEGINNING INSTALLATION.
• DO NOT STORE, INSTALL, OR OPERATE THE DOCKING STATION WHERE WATER, MOISTURE, STEAM, DUST, ETC. ARE PRESENT
• DO NOT DOCK OR UNDOCK YOUR COMPUTER UNLESS IT IS POWERED OFF. DOCKING OR UNDOCKING WITH YOUR COMPUTER IN ON, STANDBY, HIBERNATION, OR SLEEP MODES CAN CAUSE PERMANENT DAMAGE.
• FOR THE DS-PAN-1501, DS-PAN-1501-4, DS-PAN-1502, DS-PAN-1502-4, DS-PAN-1504, DS-PAN-1504-4, DS-PAN-1505 and DS-PAN-1505-4 DOCKING STATIONS: DO NOT CONNECT DIRECTLY TO VEHICLE VOLTAGE SOURCE: This product requires a certified, automotive grade, Panasonic approved 120W power source rated for a continuous, regulated 15.6 VDC output (Havis Part Number LPS-103 or equivalent). Failure to comply with this requirement will cause product damage that is NOT repairable and is NOT covered under warranty.
• FOR THE DS-PAN-1503 DOCKING STATION: DO NOT CONNECT DIRECTLY TO VEHICLE VOLTAGE SOURCE: The Panasonic TOUGHBOOK 40 requires a certified, Panasonic-approved power source rated for a continuous, regulated 15.6 VDC output. Failure to comply with this requirement will cause product damage that is NOT repairable and is NOT covered under warranty.
• Do not use a dock if docking connector pins are bent or show signs of damage.

NOTICE
FOR DOCKING STATION MODELS EQUIPPED WITH A BUNDLED POWER SUPPLY (DS-PAN-1502, DS-PAN-1502-4, DS-PAN-1505, DS-PAN-1505-4 & DS-PAN-1506) REFER TO THE SUPPLIED LIND POWER SUPPLY REFERENCE GUIDE.

Precautions

• Do not place metal objects or containers of liquid on top of the Docking Station
• If a malfunction occurs, immediately unplug the Power Supply and remove the laptop
• Use only the specified Power Supply (Part# LPS-103) with this Docking Station
• Do not connect cables to ports other than what they are specified for
• Do not leave the Docking Station in a high-temperature environment (greater than 85°c, 185° F) for a long period.

Specifications

DECLARATION OF CONFORMITY

EU DECLARATION OF CONFORMITY [CWNl]

• Manufacturer Name: Havis, Inc.
• Manufacturer Addresses: 470995 Mile, Plymouth Twp, Ml 48170USA 75Jacksonville Road, Warminster, PA, 18974, USA

This declaration of conformity is issued under the sole responsibility of the manufacturer.

• Product name: Docking Station For Panasonic TOUGH BOOK 40
• Model: DS-PAN-15XY-Z, where ‘X, Y, Z’ may be any alphanumeric character and which describes product options. May be followed by any alphanumeric characters which describe product options.
• Product Options: This declaration covers all options of the above product which bear the CE Marking.

Is in conformity with the following directives, standards, or other normative documents:

• UN ECE Regulation 10 UNECE Regulation 10.05, Paragraph 3.2.9; Clauses 6.5, 6.6, 6.7, 6.9; “Uniform provisions concerning the approval of vehicles about electromagnetic compatibility”
• EMC Directive 2014/30/EU EN 50498:2010, “Electromagnetic compatibility (EMC)- Product family standard for aftermarket electronic equipment in vehicles”
• RoHS Directive 2011/65/EU EN 50581:2012, “Technical documentation for the assessment of electrical and electronic products concerning the restriction of hazardous substances”

The object of the declaration described above conforms with Directive 2011/65/EU of the European Parliament and[CWN2) of the Council of 8 June 2011 on the restriction of the use of certain hazardous substances in electrical and electronic equipment.

Supplementary Information:
The object of the declaration described above conforms with the relevant Union harmonization legislation. This product requires the use of a recommended E-marked automotive power supply when used within vehicles.

Signed for and on behalf of Havis, Inc.
40799 Five Mile, Plymouth Twp, Ml 48170, USA March 17, 2022, Bruce Jonik, Director of Engineering, Havis, Inc.

FCC 47CFR, Part 15 compliance:
This is an FCC Class B device. Any changes or modifications to the model DS- PAN-15XY-Z not expressly approved by Havis, Inc. could void the user’s authority to operate this equipment.

Parts Included

Docking Station

Mounting Bracket (HAVIS Item Number: 25643)
Numerous hole patterns present in the Mounting Bracket will accommodate Havis Motion Devices as well as most competitors

Hardware Kit (HAVIS Item Number 17672)

This Hardware Kit includes:

1. Zip Ties (5)
2. Keys (DS-DA-503)
3. 1/4″-20 x 5/8″ long Button Head Screws (5)
4. Phillips 1/4″ -20 x 3/8″ long Screws (5)

Tools required for installation:

• 5/32″ Hex Drive
  (For attaching Mounting Bracket to Motion Device with Button Head 1/4″-20 Screws)

• #3 Phillips
  (For attaching Docking Station to Mounting Bracket with Button Head 1/4″-20 Screws)

Port Replication Capability

Port Replication Capability ros-PAN-1so1, os-PAN-1so1-4, os-PAN-1so2, os- PAN-1so2-4J

Port Replication Capability ros-PAN-1so4, os-PAN-1504-4, os-PAN-1sos, os- PAN-1sos-4J

Port Replication Capability Forward Facing
DS-PAN-1501 DS-PAN-1501-2 DS-PAN-1502 DS-PAN-1502-2 DS-PAN-1504 DS-PAN-1504-4 DS-PAN-1505 & DS-PAN-1505-4.

Antenna Identification (DS-PAN-1501-4, DS-PAN-1502-4, DS-PAN-1504-4 and DS- PAN-1505-4)

• Channel 1: User Configurable
• Channel 2: GPS/User Configurable
• Channel 3: User Configurable
• Channel 4: User Configurable

NOTE:
Please reference the Panasonic Tough Book Manual for Pass-Through Antenna Configuration Requirements.

Antenna Connectors of the TOUGH BOOK 40

Antenna Connectors (SMA)

Docking Station Antenna Interface

Cable Management and Strain Relief

DS-PAN-1501-4 DS-PAN-1502-4 DS-PAN-1504-4 and DS-PAN-1505-4

1. In the areas below, strain relief and cable management loops are designed to accept the zip ties. These ties will help with cable management and provide strain relief for the connectors.

Antenna Cable Routing
(D5-PAN-1501-4, D5-PAN-1502-4, D5-PAN-1504-4 and D5-PAN-1505-4)

1. Connect each antenna cable to the correct channel as prescribed on the previous page.
2. Route the cables as shown below, so they exit the rear of the docking station
3. Use cable ties and the strain relief features on the docking station to hold the antenna cables in this position

Installation

1. Remove the Mounting Bracket from the packaging. Install the Mounting Bracket to the Motion Device using (4) 1/4″-20 x 5/8″ long screws (Hardware Kit Item 3). Torque screws to 80 in-lbs (9.0Nm) ± 10%.
   NOTE: Numerous hole patterns present in the Mounting Bracket will accommodate Havis Motion Devices as well as most competitors Additional hardware may be required for mounting depending on the mounting device selected.

   • NOTE: We recommend applying a drop of medium-strength (blue) thread-locking adhesive to the threads of all fasteners.

2. Lower the Docking Station to the Mounting Bracket as shown. Secure with (4) 1/4″-20 x 3/8″ long screws (Hardware Kit Item 4). Torque screws to 32 in-lbs. (3.5 Nm)± 10%.

Cable Management

1. Tip the Docking Station to a position that is comfortable to work with.
2. Install all cables that are necessary for computing needs. Use Zip Ties (Hardware Kit Item 1) to strain-relieve cables at the rear of the Docking Station.
3. Route all cables along one side to ensure proper cable management and avoid pinching any cables. Strain relieves the entire cable bundle to one of the strain relief points along the corners of the Mounting Bracket to prevent tension on the connectors.
4. Create a service loop with cables to ensure that no tension is on the connectors and to enable the intended motion.
5. Tie off cables onto a stationary part of the mounting system.

Operation

Docking

CAUTION
DO NOT FORCE THE LAPTOP ONTO THE DOCKING STATION. IF THERE IS RESISTANCE, CHECK THE ALIGNMENT OF THE COMPUTER ON THE DOCKING STATION.

1. Ensure the Docking Station is unlatched before docking the Laptop. This is done by depressing the latch handle until you hear an audible click. Also, the “UNLATCHED” text in the Latch Opening will be visible.
2. With the rear of the computer elevated, load the front of the computer into the Docking Station ensuring the laptop’s front pockets align with the front hooks of the docking station.
3. Press the back of the computer onto the Docking Station until the audible click of the latch hooks engages the laptop. To check that the laptop is fully latched in the docking station, ensure that the latch handle extends flush to the front of the opening.
4. For theft deterrence, secure the computer by locking the Docking Station with the supplied key (Hardware Kit Item 2).

Undocking

1. If previously locked, unlock the Docking Station using the supplied key. (Hardware Kit Item 2)
2. Press Latch Handle into the docking station until the back of the laptop lifts off the back of the docking station.
3. Once unlatched, grab both sides of the computer and carefully lift the laptop out of the Docking Station, rear end first.

Related Products

Havis offers a wide variety of accessory products specifically for use with the DS-PAN-1500 Series Docking Station. For more information or to order, please visit www.havis.com.

LPS-103

120W Power Supply
External power supply and cable for Panasonic Toughbook 54 and 55 with cigarette lighter adaptor.

LPS-211

Power Supply Mounting Bracket
Mount a power supply or USB hub directly to your Docking Station with this versatile bracket.

DS-DA-423

Screen Support
Secure your laptop screen to prevent excess wear and reduce vibration while in use.

DS-DA-503

Replacement Keys
Set of two (2) replacement keys for the DS-PAN-1500 Series Docking Stations.

Contact Us

• www.havis.com.
• 1-800-524-9900

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>