GuangDong HG4-05 Remote Control Car Instruction Manual
- July 25, 2024
- Guangdong
Table of Contents
GuangDong HG4-05 Remote Control Car
FUNCTIONAL DEMONSTRATION
-
THENUENCY PROWER AND THE REMOTE CONTROL
First, turn on the remote control car switch and then turn on the remote control switch
After the successful frequency, the light on the remote control goes out. -
REMOTE CONTROL DISTANCE
The remote control operation distance is about 30M. -
TIME OF USE
An a full charms the nor lactate chant 96 minutes. -
LIGHT BAR
When the car is turned on, the light circle flashes blue. After turning on the remote control switch, the car’s light circle will change.
LITHIUM BATTERY CHARGING DIAGRAM
Remove the lithium battery from the remote control car and charge it with the
complimentary charging cable. The red LED light of the charging cable is on
during charging and will be turned off when the charging is complete.
BODY
REMOTE CONTROL
OPERATING INSTRUCTION
WHEN THERE ARE OBSTACLES IN FRONT OF THE REMOTE CONTROL CAR
FCC STATEMENT
RF exposure statement
This equipment complies with the FCC radiation exposure limits set forth for
an uncontrolled environment.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
FCC Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, under part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used per the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>