dormakaba Saffire LX-P Smart Door Lock Instructions
- July 25, 2024
- dormakaba
Table of Contents
dormakaba Saffire LX-P Smart Door Lock
Product Specifications
- Product Name: Saffire LX-P & Saffire EVO LZ-P
- Series: Saffire LX & Saffire EVO LZ series
- Model: IP-516418-2A – Rev 2
- Backset Adjustment Dimension Y: .032” [0.81mm] – .072” [1.83mm]
- Door Thickness Dimension X: 2.750” [70mm] standard backset
- Thread Class / Filet Finish: SAE: 2A-2B ISO: 6g / 6H
Product Usage Instructions
Installation Preparation:
- Refer to exit device manufacturer installation instructions for exit device and mortise lock cut-out specifications.
- Adjust backset according to the exit device manufacturer’s requirements.
Door Preparation:
- Ensure the door thickness meets the specified dimensions X and Y.
- Follow the high or low bevel instructions based on the door orientation (right or left hand).
- Refer to the specific tolerances and distances provided for accurate door preparation.
Backset Adjustment:
- Adjust the backset as needed based on the door thickness and specific tolerances provided.
FAQ
Frequently Asked Questions
- Q: What is the recommended door thickness for installation?
- A: The standard door thickness for installation is 2.750” [70mm] with specific backset adjustments mentioned in the manual.
- Q: How should I determine the bevel orientation for my door?
- A: Refer to the inside and outside high or low bevel instructions based on whether your door is right or left-handed.
- Q: What is the thread class and filet finish of the product?
- A: The thread class and filet finish are specified as SAE: 2A-2B ISO: 6g / 6H.
Installation Instructions
NOTES:
- FOR EXIT DEVICE AND MORTISE LOCK CUT-OUT REFER TO EXIT DEVICE MANUFACTURER INSTALLATION INSTRUCTIONS.
- BACKSET SHOWN FOR REFERENCE ONLY, ADJUST BACKSET TO EXIT DEVICE MANUFACTURER INSTALLATION INSTRUCTIONS. BACKSET TO BE ADJUSTED TO LOW AND HIGH BEVEL DOOR EDGE AS PER BACKSET ADJUSTMENT TABLE.
- DIMENSIONS ARE SYMETRICAL ABOUT UNLESS OTHERWISE NOTED.
- FOR SURFACE MOUNT VARIANTS PLEASE REFER TO IP-516418-15 FOR THE PLACEMENT OF HOLE 0.750″ & CABLE GROOVE 0.250″. HOLES 2×0.250″ NOT REQUIRED.
- GROOVE TO BE DONE ONLY IN SOLID DOORS. TO PASS WIRES INSIDE THE DOOR FOR HOLLOW DOORS.
- REFER TO SPECIFIC TOLERANCES TABLE FOR DIMENSIONS MARKED WITH #.
- DRAWING IS NOT TO SCALE.
- DIMENSIONS ARE IN INCHES [mm].
RHR
LHR
INSIDE AND OUTSIDE
DIMENSIONS
- 3D FILE GOVERNS ALL UNSPECIFIED DIMENSIONS & GENERAL TOLERANCES APPLY
BACKSET ADJUSTMENT FOR 3° BEVEL DOOR
SPECIFIC TOLERANCES
SPECIFIC TOLERANCES
DISTANCES| .030 [0.75]
HOLES| .010 [0.25]
DIMS MARKED #| +.030 [0.75]
-.000 [0.00]
WARNING
- To verify lock coverage and door operation meets expectations, dormakaba strongly recommends completing a full door mockup. This will ensure that all necessary products and parts for a successful installation are included.
- Always validate that you have selected the correct template for specific lock model being installed. The same lock model can be offered with different locking device options.
- Drawing is not to scale. Measurements are for reference only. Not a drilling template.
- If you have any questions, please contact your local sales representative or authorized reseller.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>