dormakaba YG80 Door Lock User Guide

dormakaba YG80 Door Lock User Guide

• Wiring the lock requires at least three connections; red (positive), black (negative), and blue (control).
• Ensure the strike magnet is located at the correct position in the strike for the chosen installation orientation.
• Ensure the power supply has the following current available to power the lock when supplied with the following; 2.0A for 24VDC supply with the heater on, 0.5A for 24V supply with the heater off, and 1.0A for 12VDC supply with the heater off.
• Use an appropriate wire gauge for the wire run distance between the lock and power supply.
• Do not mount the lock operating upwards.

Warranty Information
The product is covered by a 3-year manufacturers’ warranty against faulty or malfunctioning parts, components, or product. A faulty product can be returned at the customers’ expense to the seller for review. At the seller’s discretion, either a replacement lock or affected part will be supplied to remedy the fault. Installing the lock in a way that will lower the integrity of the sealing characteristics of the lock may void the warranty. Mistreatment or ill-use of the lock may void the warranty.

Installation and Operating
Instructions Download

Package Contents

Product Dimensions

How to set the operating mode.

Locate the dip switches on the product, then set as per table shown.

Strike Configuration – Disassembly

Strike Configuration – Assembly

Wiring Gauge Table

Wiring IO Table

How to wire the lock for each operating mode.

MP001907.001
DN 01031/001 03-2024

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>