ALPINE KTX-AMB1 Dynamic Ambient Light Installation Guide

ALPINE KTX-AMB1 Dynamic Ambient Light

Product Components

• Underneath dashboard light strip x2
  

• Upper dashboard light strip
  

• Front door light strip x2
  

• Rear door light strip x2
  

• Central console light strip
  

• Seatback light strips x2

• Module x5

• Touch screen panel

• Power cable (Main control box)

  • Power cable (Small control box)

• Connection cable of door light strips x4

  • Connection cable of dashboard x2

• Footwell light x4
  

  • Door storage box light x4
  • Upper dashboard light x2

• Light cable of central console
  

  • Connection cable of footwell
  • Light cable of seatback

Wiring Diagram

Main Module Sockets

• Power (Connect the power cable of ambient light to car power)
• Button (Connect the button included in the ambient light product for controlling the ambient light)
• Dynamic LED (Connect the 3 PIN dynamic LED strips, normally for contour light)
• RGB LED (Connect the 4 PIN LED strips or LED, normally for door storage box LED or footwell LED

Power Socket Definition

Button Socket Definition

Dynamic LED Socket Definition

RGB LED Socket Definition

Sub-Module Sockets

Power Socket Definition

Dynamic LED Socket Definition

RGB LED Socket Definition

Important Notice

• Please read this manual carefully and according to the steps for correct installation
• The ambient light color is set by the APP
• Use touch screen panel to control the colors

Central Console

1. Pry open and remove the original central console cover plate
   

2. Remove the original central console trim
   

3. Install our touch screen panel

4. Main module power cable connect with cigarette lighter

Dashboard

1. Pry open the cover plate of both side dashboard

2. Remove the original trim

3. Install our dashboard light strips

4. Use holt melt glue to fix the light strips

5. Cut away the raised phasic marked in red in the photo, in order to avoid damaging the LED strips

6. Install the upper dashboard light strip

Door and Seatback

1. Remove the door panel setscrews
   

2. Remove the screw showed above

3. Remove the original door trim and install our door light strips

4. Install the door storage box light on the original reserved position

5. Remove the setscrew of rear door panel

6. Remove the setscrew of rear door panel

7. Install the rear door light strips

8. Install the door storage box light on the original reserved position

9. Install the seatback light

Connection

Connect all plugs and cables

DSP Wire Connection

DSP signal wire plug-in the NO. 3 PIN of main module power cable
Other side connect to the car DSP

After Installation

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>