Highlife Bathrooms 50mm Round Metal Bottle Trap Brushed Brass Instruction Manual
- July 19, 2024
- Highlife Bathrooms
Table of Contents
Highlife Bathrooms 50mm Round Metal Bottle Trap Brushed Brass
ASSEMBLY INSTRUCTIONS
Note: Please be advised that no abrasive agents or materials can be used for cleaning this product, otherwise warranty will be void.
-
Assemble nut ( C ) onto the plated metal tube ( B ) under the top flange with the wide end facing upwards to receive the waste assembly.
Slide the nut ( D ) over the plated tube, with the wide end facing down. -
Push the plastic sleeve ( F ) into the top of the bottle trap main body ( H ) ensuring the lip seats on the neck of the trap. Insert the metal tube into the centre of the plastic sleeve and lock the nut ( D ) into position
-
This trap is designed to connect to standard 1 1 /4″ metal waste pipe. slide the nut (E) and tapered washer ( G ) over the waste pipe as shown.
Insert pipe into the trap outlet and tighten the nut. -
When fitted onto a basin waste outlet the washer (A) must be placed inside the nut(C) to form a seal between the trap and waste.
COMPONENTS
( A ) Flat Washer
( B ) Plated metal tube
( C )( D )( E ) Nuts
( F ) Plastic Sleeve
( G ) Tapered Washer
( H ) Bottle Trap Body
Aftercare
The end user is required to regularly maintain and clean product using warm soapy water and a soft cloth for the product warranty to be valid. Surfaces should be maintained using a clean damp cloth, NO corrosive and abrasive agents or materials should be used or come into contact with the surface finish, as this will invalidate your product warranty.