HOFTRONIC 4406882 Aurora LED Floor Lamp RGB User Manual

HOFTRONIC 4406882 Aurora LED Floor Lamp RGB

SAFETY INSTRUCTIONS

1. Do not use the power supply beyond the specified range(100-240V,50Hz).
2. Avoid scratching the surface and wires of the lamp during installation.
3. Do not install the lamp outdoors.
4. The lamp should not be close to corrosive chemical objects or gases. It can not be washed with water. It can only be wiped with a clean soft cloth.

INSTALLATION INSTRUCTIONS

1. Remove everything from the box. Check if you have the lamp with one leg attached via the wire. 1 separate leg to be attached and 1 tool bag.
2. Slide the separate leg onto the connection on the lamp body as shown in Fig.1
3. Tighten 2 screws in the holes on the leg well. Loose tightening may result in your lamp falling over or damage later on.
4. Gently pull the cable tight and this will cause the attached leg to move into the connection on the lamp body.
5. Tighten 2 screws in the holes on the leg as shown in Fig.3

CAUTION!
This male and female connector should be connected properly according to the directions on this drawing and arrows same side on the surface to insert. Otherwise the lamp will be broken and cause short circuit

REMOTE CONTROL

BASIC PARAMETERS

1. Working voltage : 5-24V
2. Effect mode : 358 effects
3. Control points : Max up to 2048 pixels points
4. Remote control distance : Mini version 30 meter, plastic box version 100 meter
5. Battery model : 2 pcs No.7 batteries (remote control battery)

KEY OPERATION INSTRUCTIONS

First remove the plastic foil from the remote control to ensure that the touch screen is working properly.

• Adjust the number of pixel points function: First press ON/OFF key to shut down. ln the shutdown state, long press A key for 5 seconds to enter the number of pixel points adjustment menu. At this time,press M+ and M- to adjust the number of pixel points. After adjustment, press ON/OFF to save.
• Adjust RGB order function : If the color of the led strip and the color ring cannot match, you need to adjust the RGB order. The adjustment method is the same as the number of adjustment pixel points .First press the ON/OFF key to shut down. In the shutdown state,long press the A key for 5 seconds to enter the number adjustment menu. At this time press the B+ key to Adjust the RGB order until the color Order of the 15 LED in front of the led strip ls red, green and blue After adjustment press ON/OFF key to save.
• Pairing the remote control: In any case, long press the blue key at the top of the color ring for 5 seconds (no shaking left and right), to realize the remote control one-to-one matching function. After the matching is successful, the blue light of the led strip flashes three times.At this time, only this remote controller can control this controller.
• Deleting the remote control: In any case, press and hold the yellow key at the bottom of the color ring for 5 seconds (no shaking left and right), delete the remote control matching function. After successful delete, the yellow light of the led strip flashes three times, at this time, all remote controllers can control the controller. First remove the plastic foil from the remote control to ensure that the touch screen is working properly

INTENDED USE / APPLICATION

Product designed for the use in households and for other similar general applications.

MOUNTING

Technical changes reserved. Read the manual before mounting. Mounting should be performed by an appropriately qualified person. Any activities to be done with disconnected power supply. Exercise particular caution. Product has a protective contact/terminal. Failure to connect the protective lead may lead to electric shock. Mounting diagram: see pictures. Check for proper mechanical fastening and connection to electrical power prior to first use. The product can be connected to a supply network which meets energy quality standards as prescribed by law. To maintain the proper IP protection level, the right diameter of the power cable should be selected for the cable gland used in the product.

FUNCTIONAL CHARACTERISTICS

The product can only be used indoors.

USAGE GUIDELINES / MAINTENANCE

Any maintenance work must be performed when the power supply is cut off and the product has cooled down. Clean only with soft and dry cloths. Do not use chemical detergents. Do not cover the product. Ensure free air access. Product may heat up to a higher temperature. Product can only be supplied by rated voltage or voltage within the range provided. It’s forbidden to use the product with damaged protective cover. Product must not be used in unfavourable conditions, e.g. dust, water, moisture, vibrations, explosive air atmosphere, fumes, or chemical fumes, etc. Non-demountable product. Not suitable for independent repairs.

ENVIRONMENTAL PROTECTION

Keep your environment clean. Segregation of post-packaging waste is recommended. This labelling indicates the requirement to selectively collect waste electronic and electrical equipment. Products labelled in this way must not be disposed of in the same way as other waste under the threat of a fine. These products may be harmful to the natural environment and health, and require a special form of recycling/neutralising. Products labelled in this way should be returned to a collection facility for waste electrical and electronic goods. Information on collection centres is provided by local authorities or sellers of such goods. Used items can also be returned to the seller when new product is purchased, in quantity no larger than the purchased item of the same type. The above rules regard the EU area. In the case of other countries, regulations in force in a given country must be applied. Contacting the distributor of our products in a given area is recommended.

COMMENTS / GUIDELINES

Failure to follow these instructions may result in e.g. fire, burns, electrical shock, physical injury and other material and non-material damage. For more information about Hoftronic products visit www.hoftronic.com. Hoftronic shall not be responsible for any damage resulting from the failure to follow these instructions. Hoftronic reserves the right to make changes in the manual – the current version can be downloaded at www.hoftronic.com

DECLARATION OF CONFORMITY

DOCUMENTATION

This product has been manufactured and supplied in compliance with all relevant regulations and directives applicable to all member states of the European Union. The product complies with all applicable regulations and rules in the country of sale.
Formal documentation such as the declaration of conformity, the safety data sheet and the product test report is available upon request.

CE DECLARATION

The product complies with the following directives:

• LVD: 2014/35/EU
• EMC: 2014/30/EU
• RoHS: 2011/65/EU

The complete Declaration of Conformity Document (DOC) is available upon request.

Imported by
HOF Trading B.V.
Fahrenheitstraat 11, 6003 DC Weert , The Netherlands Made in P.R.C.
www.hoftronic.com

References

• Adomino Premium Domain Names
• HOFTRONIC - HOFTRONIC

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>