LandS 2ARW2-SMARTUP1 SMART UP 1 Remote Control User Manual
- June 22, 2024
- LandS
Table of Contents
LandS 2ARW2-SMARTUP1 SMART UP 1 Remote Control
REMOTE CONTROL – 1 CHANNEL
See “pairing the transmitter” in the receiver unit manual to associate the remote control with a compatible receiver. Each remote control can be combined to more than one receiver (up to 6). In the event of operation failure, check that remote’s battery is functioning and correctly inserted. In the case of further malfunction, proceed with a new coupling of the remote control with the receiver.
A CAMBIO TEMPERATURA COLORE
Color temperature change
EDC LED only
STEP
Single press
B STEP DIMMER
Single press
PROGRESSIVE DIMMER
Long press
WARNING : the safety of the device is guaranteed only if it is used in compliance with these instructions that must be kept in a safe place.
The device MUST NOT be tampered with in any way whatsoever; no operations other than those indicated in the instructions for use are allowed. The product does not contain any parts that should be repaired by the use: in the event of failures, the product must be replaced exclusively by the manufacturer or the assistance service. Keep away from heat sources. Keep battery out of children’s reach. Swallowing a battery could be fatal. In case this event happens, urgently seek medical attention. These batteries do not contain Mercury, Cadmium, or Lead above the levels defined by the battery directive 2006/66/EC
WEEE
Waste Electrical and Electronic Equipment
The use of the symbol indicates that this product and its batteries may not be
treated as household waste.
Packaging disposal
RF exposure statement
This equipment complies with the FCC radiation exposure limits set forth for
an uncontrolled environment. This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter.
FCC Warning
(FCC ID: 2ARW2-SMARTUP1)
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference
that may cause undesired operation.
NOTE : This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.