TECNO CL6 Camon 30 Smartphone User Manual
- July 10, 2024
- TECNO
Table of Contents
TECNO CL6 Camon 30 Smartphone
Product Specifications
- Front Camera: O LED_678
- Main Board : MAIN_BOARD
- Camera Types: 32M, 50M, 2M, 8W
- Connectivity: Type-C USB, NFC
- Operating System: HiOS (Android)
Exploded diagram specification
| 1 | OLED_678 | 2 | LCM_HEAT_FILM |
|---|---|---|---|
| 3 | FRONT_COVER | 4 | SIM CONNECTOR |
| 5 | 0_50M_FCAM_BRACKET_RN M | 6 | BATTERY |
| 7 | MAIN_BOARD | 8 | 32M CAMERA |
| 9 | 50M CAMERA | 10 | 8W CAMERA |
| 11 | 2M CAMERA | 12 | SIDE KEY FPC |
| 13 | COAXIAL CABLE | 14 | RECEIVER |
| 15 | LCM_CON_HEAT_SINK | 16 | MIDDLE HOUSING B-COVER |
| 17 | 8W CONDUCTIVE ADHESIVE | 18 | R-MAIN |
CAM-CON-COP-FOIL
19| 2M CAMERA RUBBER| 20| SCREW M1.4 L3.5
21| 2M CANERA DECORECTION| 22| BATTERY COVER
23| SCREW M1.2 L1.7| 24| CAM_GLASS DECPRATIOPN
25| CAMERA DECPRATIOPN| 26| CAMERA FILM
27| SCREW M1.2 L1.7| 28| SPK BOX
29| MAIN CONNECTOR ZIF/BTB)| 30| SUB BOARD
31| FINGERPRINT| 32| MOTOR
33| AUDIO JACK RUBBER| 34| TYPE-C USB RUBBER
Know your phone
- Front camera
- Volume + button
- Volume – button
- Power button
- NFC
SIM/SD card installation
- Power off your phone.
- Refer to the following picture for SIM/SD card installation.
Charging the phone
- You can charge your phone with a charger or by connecting it to a computer using a USB cable (comes with the phone).
- Use only TECNO chargers and cables. Other chargers or cables may damage the phone and invalidate its warranty.
FCC
- This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
- Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Information to the user.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, under part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used by the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Specific Absorption Rate (SAR) information:
This mobile phone meets the government’s requirements for exposure to radio
waves. The guidelines are based on standards that were developed by
independent scientific organizations through periodic and thorough evaluation
of scientific studies. The standards include a substantial safety margin
designed to assure the safety of all persons regardless of age or health. FCC
RF Exposure Information and Statement The SAR limit of the USA (FCC) is 1.6
W/kg averaging over one gram of tissue. Device types: CL6 (FCC ID: 2ADYY-CL6)
has also been tested against this SAR limit. The highest SAR value reported
under this standard during product certification for use at the ear is 1.117
W/kg and when properly worn on the body is 0.958 W/kg.
Body-worn Operation
This device was tested for typical body-worn operations. To comply with RF
exposure requirements, a minimum separation distance of 1.0 cm must be
maintained between the user’s body and the handset, including the antenna.
Third-party belt clips, holsters, and similar accessories used by this device
should not contain any metallic components. Body-worn accessories that do not
meet these requirements may not comply with RF exposure requirements and
should be avoided. Use only the supplied or approved antenna.
HiOS runs on AndroidTM OS.
Android is a trademark of Google LLC.
FAQ
- Q: Can I use any charger to charge the phone?
- A: No, it is recommended to use only TECNO chargers and cables to avoid damage to the phone.
- Q: How do I install a SIM card?
- A: Power off your phone and refer to the provided picture for SIM/SD card installation instructions.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>